Exido 245-065 manual Cleaning the Kettle, Information on Disposal and Recycling of this Product

5.Plug in and switch the power on.

o Caution! If you set the on/off switch (6) to the "I" position before replacing the kettle on the base, the kettle switches on automatically when replaced on the base. For safety’s sake, check the on/off switch position before replacing the kettle on the base to avoid accidentally starting the kettle.

6.Switch on the appliance by switching the on/off button forward to "I". The on/off indicator in the water indicator lights up, when the appliance is on and heating the water.

The water will boil within a few minutes, depending on the amount in the kettle. If you want to interrupt the boiling, you can do this at any time by switching the on/off button backward to "O". Once the water is boiling, the kettle will automatically switch off thanks to the integrated thermostat. The indicator light comes off when the appliance is stopped and the on/off button automatically switches to position “0”.

Anti boil-dry device

If you switch the kettle on without having filled it with water, or when the water level is below the “MIN” mark, the anti boil-dry device will automatically switch it off. The kettle can be switched on normally, as soon as it is filled with a sufficient amount of water.

Storage

If the kettle is to be stored for any length of time without use, the cord can be rolled up around the inside of the base. Ensure the appliance is clean and dry before storing.

CLEANING THE KETTLE

When cleaning the appliance, you should pay attention to the following points:

•Remove the plug from the wall socket and allow the appliance to cool down before cleaning.

•Do not immerse in water or any other liquid.

•Wipe using a well-wrung cloth and hot water. A little detergent can be added if the appliance is heavily soiled.

•Never use scouring powder, steel scourers or other strong cleaning agents to clean the interior or exterior surfaces of the appliance, as they may scratch the surfaces.

•Make sure that no water gets into the connector on the base or the hole in the underside of the kettle.

Decalcifying the kettle

The lime content of ordinary tap water means limescale may gradually be deposited inside. This limescale may be loosened using acetic acid (NOT ordinary vinegar) or descaler, available in supermarkets, etc.

1.Mix 1 dl acetic acid with 3 dl cold water, or follow the instructions on the descaler packaging.

2.Pour the solution into the kettle and switch it on.

3.Allow the solution to boil twice and then pour it out.

4.To remove the final residues of limescale and acetic acid, pour cold water into the kettle again (up to the "MAX" mark) and switch it on.

5.Pour out the water once it has boiled.

6.Repeat the process described under points 4-5 three times.

7.The filter (11) may be gently removed from the locking devices in the spout (1).

8.Place the filter in a cup with descaler for a couple of hours and thoroughly rinse it after decalcifying.

9.Gently replace the filter in the spout so that it is gripped and held in place by the locking devices. The appliance now ready for use.

INFORMATION ON DISPOSAL AND RECYCLING OF THIS PRODUCT

Please note that this Adexi product is marked with

this symbol:

This means that this product must not be disposed of together with ordinary household waste, as electrical and electronic waste must be disposed of separately.

In accordance with the WEEE directive, every member state must ensure correct collection, recovery, handling and recycling of electrical and electronic waste. Private households in the EU can take used equipment to special recycling stations free of charge. In some member states you can, in certain cases, return

the used equipment to the retailer from whom you purchased it, if you are purchasing new equipment. Contact your retailer, distributor or the municipal authorities for further information on what you should do with electrical and electronic waste.

GUARANTEE TERMS

The guarantee does not apply:

•if the above instructions are not followed

•if the appliance has been interfered with

•if the appliance has been mishandled, subjected to rough treatment, or has suffered any other form of damage

•If faults have arisen because of faults in your electricity supply.

Due to the constant development of our products in terms of function and design, we reserve the right to make changes to the product without warning.

QUESTIONS AND ANSWERS

If you have any questions regarding use of the appliance and cannot find the answer in this user guide, please try our website at www.adexi.eu.

Go to the "Consumer Service" menu, click on "Question & Answer" to see the most frequently asked questions.

You can also see contact details if you need to contact us for technical issues, repairs, accessories and spare parts.

13