Oster 3167, 3168, JUICE EXTRACTOR Instructions for USE, Before Using Your Juice Extractor

INSTRUCTIONS FOR USE

BEFORE USING YOUR JUICE EXTRACTOR

Follow the assembling instructions listed below before using your Oster® Juice Extractor:

Figure 1

Figure 2

•Before you start assembling your juice extractor, make sure it is unplugged and it is placed on a dry and leveled surface

•Place filter basket on top of the motor base (Figure 1)

•Place the stainless steel filter on top of the filter basket turning it until it fits into the grooves of the motor shaft

(Figure 2)

•Place juicer cover/lid on top of the filter basket (Figure 3)

•Place removable food chute on top of the lid and turn it until tabs fit into tab grooves or by aligning the arrows on the chute with the arrows on the lid. Once the tabs are inside the grooves, turn the chute clockwise until it locks into position (Figure 4)

•Raise the one movement safety locking arm and place it on the grooves on the sides of the lid. The food chute fin will fit into the safety switch located in the center of the locking arm. This is a safety feature that will ensure the unit will not operate unless the lid is properly locked. The safety locking arm should now be up and locked into place on top of the juicer lid (Figure 5)

•Place the pulp container into position by tilting it slightly

(Figure 6)

•Place the 34 oz. pitcher under the spout located on the right hand side of the juicer by tilting it slightly. Other jars or glasses can be used as well (Figure 7). The froth separator will allow to serve the juice without the foam

Figure 3

Figure 4

Figure 6

Figure 5

Figure 7

4