HOW TO USE
To Set the Clock:
1.Plug the Power Cord into the wall outlet.
2.Press the Program (PROG) Button once and the word ‘CLOCK’ will be displayed.
3.Press the HOUR and MINUTE (MIN) Buttons to select the correct time. NOTE:
a)The clock will show a 12 hour cycle and the ‘AM’ and ‘PM’ will change.
b)To scroll through the numbers faster, press and hold the Hour and Minute Buttons.
4.Press the PROG Button once to set the time. If no button is pressed for 10 seconds, the ‘CLOCK’ will disappear from the Display Window and you will have to start over from #2.
Immediate Brewing:
1.Fill the Water Reservoir with fresh cold water for the desired number of cups.
NOTE: Do not fill above the MAX line or less than the MIN line indicated on the Water Reservoir.
2.Press the Filter Basket Release Button and the Filter Basket Holder will swing outward. Fit a #4 coffee filter into the Filter Basket and fill with the desired amount of ground coffee.
NOTE: Use ground coffee specifically for automatic drip coffee makers. Usually one Coffee Measuring Scoop or a level tablespoon of ground coffee is used for each cup of coffee. Adjust the amount to your personal taste.
3.Close the Filter Basket Holder.
NOTE: If the door does not close completely, check to see that the Filter Basket and coffee filter are properly seated in the Filter Basket Holder then snap the door into place.
4.Place the Carafe with Lid on the Keep Warm Plate.
5.Plug into a 120 Volt AC outlet.
6.Press the ON/OFF Button once and the red RUN Indicator Light will illuminate indicating that the Coffee Maker is in the brew cycle.
In a few minutes the coffee will be brewed and the Coffee Maker will
automatically switch over to ‘Keep Warm’ mode for a maximum of 2
hours. Press the On/Off Button twice or unplug the appliance to 4 cancel the ‘Keep Warm’ mode. Both indicator lights will be out.