ENGLISH
Before first use:
•Before using your Chopper Blender for the first time, make sure it is disconnected from the electrical supply, then remove all packaging.
•All parts should be cleaned before use.
•Clean all parts as recommended in the section “How to take care of your Chopper/Chopper Blender”
•The motor housing (9) must only be cleaned with a damp cloth, and dried thoroughly before use.
•To clean the Blender jar (3), add 0.5L of warm water and a little detergent to the jar.
•Fit the jar to the Motor housing & connect it to a suitable electrical supply.
•Run the Blender for a few seconds until clean.
•Rinse, repeat & rinse again.
•Dry carefully, taking care when approaching the blades as these are very sharp.
•All other parts can be washed using a mid detergent and warm water. These parts are not dishwasher safe and must be hand washed.
•After washing, rinse and allow all parts to dry thoroughly before
•Take care when handling the cutting blades as they are sharp.
How to assemble your Chopper (FX350)
•Place the motor housing (9) on a flat, stable surface.
•Place the bowl (7) over the stem on the motor housing.
•Fit the blade (6) over the boss on the bowl. Press down gently to make sure it is locked in place.
•Fit the cover (5) over the bowl; rotate
How to assemble your Blender (FX350B)
•Place the motor housing (9) on a flat, stable surface.
•Place the blender lid (2) on top of the blender jar; rotate
•Fit the blender lid cap (1) into the blender lid & rotate
•Place the Blender jar (3) on the motor housing and rotate it in an
Note: The blender will not work unless it is correctly fitted.
How to use your Chopper (FX350)
•This appliance is designed to chop dry ingredients such as meat.
•Do not use this appliance for any other purpose. For indoor domestic use only.
•Prepare the ingredients by cutting them into small cubes and place them in the bowl (7). Do not
•Fit the cover (5) over the bowl and rotate
•
To avoid a hazard, this appliance must only be used for chopping dry ingredients. Note: The chopper will not work unless the cover is correctly fitted.
Press the on / off switch (8) down.
•The unit should only be operated for 5 to 15 second pulses only. Never operate the chopper continuously for longer than 45 seconds at a time. Always allow the appliance to cool down for a minimum of 15 minutes before next use.
•When the correct consistency is achieved, disconnect the unit from the electrical supply.
•Remove the cover, the blade and then remove the bowl & transfer the ingredients to a suitable container.
•Take care when handling the cutting blades as they are sharp.