mincer
power unit locking lever attachment outlet on/off speed control spanner
ring nut
mincer screens: fine, medium, coarse
cutter scroll mincer body feed tube tray pusher dish/cover
storage unit for kebbe and sausage adaptors
to assemble
1Fit the scroll inside the mincer body.
2Fit the cutter – cutting side outermost . Ensure it’s seated
properly – otherwise you could damage your mincer.
3Fit a mincer screen . Put the notch over the pin.
●Use the fine screen for raw meat; fish; small nuts; or cooked meat for shepherd’s pie or meat loaves.
●Use the medium and coarse screens for raw meat; fish and nuts.
4 Loosely fit the ring nut.
to use the mincer
1With the mincer attachment in the position shown , locate in the
outlet. Rotate the mincer body so that the feed tube is upright.
2Tighten the ring nut firmly by hand. ● If you experience poor results when mincing meat, switch off and unplug
the machine. Dismantle and clean the attachment, then
the attachment and refit to the
power unit. Tighten the ring nut. using the spanner provided
3Fit the tray. Put the dish/cover under the mincer to catch the food.
4Thaw frozen food thoroughly before mincing. Cut meat into 2.5cm (1”)
5Switch to speed 2. Using the pusher, gently push the food down the feed tube, one piece at a time. Don’t push hard – you could damage your mincer.
Note:
Speed 1 is for extruding sausages, kebbe and for use with the optional attachments.
●If the machine stalls or overheats during use, it will stop mincing and emit a quiet humming noise. In the case of a stall, switch the machine off, then turn the control to R (reverse) for a few seconds to release the clogged food. Switch off and unplug the machine and remove any clogged material. However, if the machine overheats, switch the machine off and allow it to cool down for 1 hour before continuing the mincing operation.
●When selecting reverse, always wait until the machine stops operating
before turning the speed control to the reverse (R) position.
6Switch off and unplug after use.
7Loosen the ring nut. If necessay use the spanner provided.
8Move the locking lever towards the back of the unit, then rotate the feed tube towards the front of the machine, then pull free.
5