Preset Tuning 2
1 | 2 | 3 | 1 | 2 | 3 |
TUNER 1 |
|
|
| TUNER 2 |
|
|
How to select preset stations
1Select the AM or the FM band by pressing the corresponding button.
2Press the PRESET button.
3Select a preset channel using the numeric buttons.
Or press the TUNING/PRESET button repeatedly until the desired preset station is found.
Memory Backup
Settings are stored permanently, even when power is turned off and the unit is unplugged.
Troubleshooting
If you experience any problems with the unit, please take a moment to look through this chart and see if you can solve the problem yourself before you call your dealer or service center.
No power
eCheck the connection to the AC power supply. Check and make sure the AC source is not a switched outlet and that, if it is, the switch is turned on. Make sure there is power to the AC outlet by plugging another item such as a lamp or fan.
Cannot listen to any station, or signal is too weak.
eMake sure the antenna is properly connected. eTune in the station properly.
eIf a TV is near the unit, turn it off.
eInstall the antenna again after relocating it to a better reception position.
eAn external antenna may be required.
Though the broadcast is stereo, it sounds monaural.
ePress the FM MODE button.
Remote control doesn't work.
ePress the POWER switch to turn the unit on. eIf the batteries are dead, change the batteries.
eUse remote control unit within the range (5m /15ft) and point at the front panel.
eClear obstacles between the remote control unit and the main unit.
eIf a strong light is near the unit, turn it off.
If normal operation cannot be recovered, unplug the power cord from the outlet and plug it again.
10