Defy Appliances C375 Defrosting, To replace a faulty light bulb proceed as follows, Cleaning

Defrosting

The Appliance is Frost Free and will not require manual defrosting.

∙ Refrigerator defrost water will be channeled to an evaporation pan located above the compressor at the rear of the refrigerator. (fig 8)

∙ Ensure that the drain pan is firmly secured above the compressor.

To replace a faulty light bulb proceed as follows:

∙

∙

Switch of at the wall socket and remove the power plug from the socket. Unscrew and replace the faulty bulb with an E14 screw cap type 15 Watt bulb

(fig 9 and 10).

Cleaning

∙ Always disconnect the plug from the mains socket before cleaning any part of the re- frigerator.

∙ Clean the inside of the appliance whenever necessary using a damp cloth and a solution of warm water and Bicarbonate of Soda ( 1 table spoon to every 2 litres of water ).

∙ Dry with a soft cloth.

∙ Do not use pot scourers or abrasive powders to clean the appliance.

∙ Spillages, especially citric and acidic juices, must be wiped up immediately as they could stain the product.

∙ Shelves, freezer baskets, crispers and door shelves may be removed for cleaning pur- poses.(fig11 and12)

∙ The back of the unit may be vacuumed or dusted using a soft bristle brush.

∙ A mild furniture polish may be used on the exterior cabinet to add lustre and protect against finger marks.

∙ If the refrigerator will not be used for an extended period, it is best to unplug at the wall socket and leave both doors slightly ajar. This will prevent unpleasant odours from forming.

∙ Inspect the door gaskets at regular intervals and clean with water only. Wipe dry.

Moisture formation in the refrigerator compartment.

∙

∙

If the refrigerator is located in a hot and humid area, and the door is opened frequently, water droplets or dew may form on the interior walls.

This has no effect on the performance and the water may simply be wiped up using an ab- sorbent cloth.

PAGE 10 OF 15