Removing and Replacing the Automatic
Ice Cube Dispenser Bin (]RSD226 Only)
Lift the front of the Automatic Dispenser bin and pull it straight out. Wash the bin occa- sionally in mild soap and lukewarm water. To replace the bin, push it all the way back until the bottom of the bin is behind the raised edge at the front of the shelf it rests upon. Make sure the tabs, at the back of the bin, that turn the spiral auger are positioned be- tween the prongs from the auger motor.
Operating Your Automatic Ice Cube Dispenser
(]RSD226 Only)
ing it as high as possible (just below the ice chute).
Prevssenthet iceglassagcubes fraominstmissinthe pagddeyoud rleveglassratbytheholleftd-IH side of the fountain.To stopdispensingice, release
pressurejust enough to stop the dispenser motor and leave the glass in place to holdthe door open until ice stopsfalling. With a littlepractice,you will learn to anticipatewhen to release pressureto pre-
ventan unwanteddispenseof ice,whichoccurseach one and one half seconds.
After installation,it may take 1 to 2 daysto fill the
AutomaticDispenser bin with cubes.
Operating Your Water Dispenser (lRSD226 Only)
To dispense water,press a containeragainst the pad- ded lever at the right side of the fountain. To stop the water flow, release pressure. To minimize splashing, hold the container as high as possible.
When you first operate your dispenser or after recon- necting water to your refrigerator, air will escape from the dispenser for a few minutes before water begins to flow. Draw 10glasses of water and empty them in the kitchen sink. Thiswill insure complete filling of the reser- voir with fresh water.
Spill Tray
Do not discard water into the grille at the bottom of the fountain. This is a spill area, not a drain. Normal spills will be evaporated in the recessed area below the spill shelf
grille. Excessive spills should be removed with an absorbent sponge or cloth. The spill area should be cleaned occasionally.
Fountain Light
The push button light switch is located behind the panel at the top and on the right side of your fountain. For replacement, use a 120v, 7 watt bulb.
13