MaxTech Transceiver manual Decimal Actual Delay Sync Time Equivalent Used

B: Remotes O nly – ~/MENU A A B

En ters the num eric entry s creen. D elays th e Radio rem ote un its on ly. PO RT 2 will trigger immediately. Remote units will trigger after the displayed delay. If the contact time for the M ultiM AX (set for T RAN SM IT mode) is longer than the delay, P O RT 2 will remain contacted f or the delay time rath er than th e contac t time.

C: Rear C urtain – ~/MENU A A C

En ters th e Rear C urtain s creen . Us e this m ode to trigger th e flash at the end of an expos ure rather than at the begin ning . In this mod e both the Rad io remote trigger and PORT 2 are delayed.

Us e the •– keys to set the rear curtain sync time

equal to the c amera’s sh utter s peed. C omm on rear			Rear Cu rtain Screen
curtain sync times are available per the table below:
Re ar C urtain		Decimal	Actual Delay
Sync Time		Equivalent	Used
1/1		1 second	0.98 seconds
½		0.5 seconds	0.49 seconds
¼		0.25 seconds	0.24 seconds
1/8	0.125 seconds		0.119 seconds
1/15	0	.0667 seconds	0.062 seconds
1/30	0	.0333 seconds	0.029 seconds
1/60	0	.0167 seconds	0.014 seconds

LFor rear curtain sync times other than the ones displayed above, or for fine tuning rear curtain times for your specific equipment, press ~/MENU to return to the m ain screen. Press ~/MENU A A A (see the section A :D elay R em otes + P O R T 2, Page 32) and adjust the delay number as needed.

33