Behringer EX3200 user manual Controls, Multiband Processor Section

Page 12

4. CONTROLS

Fig. 4.1: ULTRAFEX PRO front panel

The BEHRINGER ULTRAFEX PRO has two identical channels and provides 5 illuminated push-button switches, 5 rotary controls, and 13 LEDs per channel.

4.1 The Multiband Processor Section

4

8

2

3

5

6

7

1

1

2

Fig. 4.2: Controls of the Multiband Processor section

The IN/OUT switch activates the relay and puts the corresponding channel into operation. With the switch in the OUT position, the unit is bypassed.

The AUTO NR switch (AUTO NOISE REDUCTION) activates the automatic noise reduction system. If the switch is not depressed, the section is switched off and the unit operates with maximum effect.

3

The NR SENSITIVITY control adapts the sensitivity of the Natural Sonic processor to the input level of the program material. The subsequent EFFECT meter helps you to adjust the NR SENSITIVITY control.

4

In conjunction with the NR SENSITIVITY control, these thirteen EFFECT meter LEDs provide correct level indication for the unit. The LEDs display the amount of sound enhancement.

+Please make sure, that the sensitivity of the unit is high enough especially at low-level signals. Otherwise audible pumping may occur. The first LED should always be illuminated even at low-level signals and should only go off when the music stops.

5

The TUNE control sets the lower cutoff frequency of the high-pass filter. Using this control you can select the frequencies that are routed to the Natural Sonic processor. The cut-off frequency can be adjusted within a range of 1 to 8 kHz.

6

The PROCESS control determines the function of the device. When turning the control in clockwise direction, the Exciter function is activated, which increases the signal’s transparency and sharpness. Consequently, the ULTRAFEX PRO can be adapted to the program material, to suit the application on hand as well as any personal sound preferences.

+Please note that with classical program material, acoustic instruments or with output signals that already include sufficient treble frequencies, the “Enhancer” setting should be preferred. However, when processing, for instance, a “slapped” bass guitar, it is the “Exciter” setting which should dominate.

12

4. CONTROLS

Image 12
Contents EX3200 EG-Declaration of Conformity Safety Instructions Detailed Safety InstructionsUltrafex PRO Foreword Table of Content Introduction Design ConceptIntroduction IntroductionIntroduction Design Concept High Quality Components And DesignInputs And Outputs Design ConceptInstallation InstallationRack Mounting Mains VoltageDifferent plug types Controls Multiband Processor SectionControls Bass Processor Section Surround Processor SectionRear Panel Control Elements Of The Ultrafex PRO Control elements of the rear panelTechnical Background Design Concept Of The Ultrafex PROPsycho-Acoustic Background Technical BackgroundOn Psycho-Acoustic Devices Bass Processor Of The Ultrafex PRO Surround Processor Of The Ultrafex PROApplications Basic ApplicationsApplications Basic Settings Using the Ultrafex PRO as sidechain processorTypical Applications Behringer Ultrafex PROApplications Specifications Power Supply § 5 Warranty Transferability§ 7 Other Warranty Rights PhysicalWarranty Warranty