Kramer Electronics spk-cs12, spk-cs20 user manual Installing the Half-Tile Size Speaker

Page 13

3. If required, daisy-chain the next speaker (see Section 4.3).

Note: Do not over-tighten the screws. It may cause damage to both the speakers and the surface.

4.6Installing the Half-Tile Size Speaker

When installing the half-tile size model:

1.Remove the ceiling tile.

2.Cut the ceiling tile in half (to 30x60cm).

3.Place the ceiling mounting bracket (supplied with the half-tile unit only) between the ceiling rails, as illustrated in Figure 9.

Figure 9: Placing the Ceiling Mounting Bracket

4.Drop the half-tile size speaker in the appropriate opening, so it is supported

by the ceiling rails and the ceiling mounting bracket (see Figure 10).

No screws are needed.

ESD Ceiling Speaker - Installing the ESD Ceiling Speaker

11

Image 13

Contents ESD Complete K-overage Ceiling Speaker Figures Complete K-overage ESD Ceiling Speakers Applications IntroductionAchieving the Best Performance Getting StartedOverview Bass port for a bass reflex effect for educational models Top View Underside View Defining the ESD Ceiling SpeakerChoosing the Best Location Installing the ESD Ceiling SpeakerInput Pinout Determining the Number of Speakers Needed and their Location Amplifier Preparing the ESD Ceiling Speaker for Operation Installing the Tile Size SpeakerFitting the Tile Size Speaker Placing the Ceiling Mounting Bracket Installing the Half-Tile Size SpeakerReplace half of the ceiling tile see Figure ESD Ceiling Speaker in a Boardroom Setup Dimensions Technical SpecificationsOnly the first purchase customer may enforce this warranty Safety Warning