Kramer Electronics Operating the VS-66H3 6x6 Hdmi Matrix Switcher, Acquiring the Edid

Operating the VS-66H3 6x6 HDMI Matrix Switcher

7Operating the VS-66H3 6x6 HDMI Matrix Switcher

This section describes:

•Switching an input to an output (see Section 7.1)

•Acquiring the EDID (see Section 7.2)

•Storing and recalling switch settings (see Section 7.3)

•Resetting the VS-66H3(see Section 7.4)

•Connecting to the VS-66H3via RS-232 (see Section 7.5)

•Connecting to the VS-66H3via Ethernet (see Section 7.6)

7.1Switching an Input to an Output

To switch an input to an output:

•Press an output button followed by an input button to switch the selected input to the selected output

7.2Acquiring the EDID

You can acquire the EDID from any of the following:

•One output to one or more of the six inputs (see Section 7.2.1)

•Several outputs and inputs simultaneously (see Section 7.2.2)

•The default EDID (see Section 7.2.3)

Note: Attempting to acquire the EDID from an output that does not have a display device connected to it results in the default EDID being acquired.

7.2.1Acquiring the EDID from One Output

Note: You can assign the EDID from one output to any or all of the six inputs.

To acquire the EDID from a display device connected to one of the outputs:

1.Press the EDID and STO buttons simultaneously and hold them for 3 seconds.

Both buttons flash.

2.Press the input button to which the EDID will be copied. The selected input number flashes on the display.

3.Select the output from which the EDID is to be acquired.

4.Press the EDID button.

The EDID is stored when the display returns to normal and the EDID and STO buttons stop flashing.

11