Airlux Group 13467-1200 (0512) Care and Cleaning, Common Drying Problems, Inside, Outside

Care and Cleaning

Clean lint screen after every load.

Do not store or place laundry products on top of dryer at any time. They can damage the finish or controls.

To reduce risk of fire or serious injury to persons or property, comply with the basic warnings listed in Important Safety Instructions, pages 2-3, and those listed below.

•Before cleaning the dryer interior, unplug the electrical power cord to avoid electrical shock hazards.

•Do not use any type spray cleanser when cleaning dryer interior. Hazardous fumes or electrical shock could occur.

Inside

•Clean the lint screen after every load. Lint build-up in the screen restricts air flow, which causes longer drying times. The screen is located at the bottom of the door opening. Remove by pulling straight up. Remove the lint and replace the screen.

•Occasionally a waxy build-up may form on the lint screen from using dryer-added fabric softener sheets. To remove this build-up, wash the lint screen in warm, soapy water. Dry thoroughly and replace. Do not operate the dryer without the lint screen in place.

•If the dryer drum becomes stained from noncolorfast fabrics, clean the drum with a damp cloth and a mild liquid household cleanser. Remove cleanser residue before drying the next load.

•Every 18 months an authorized servicer should clean the dryer cabinet interior and exhaust duct. These areas can collect lint and dust over time. An excessive amount of lint build-up could result in inefficient drying and possible fire hazard.

Outside

•Clean the cabinet with mild soap and water. Never use harsh, gritty or abrasive cleansers.

•If the cabinet becomes stained, clean with diluted chlorine bleach [1/2 cup (120 ml) in 1 quart (.95 liter) water]. Rinse several times with clear water.

•Remove glue residue from tape or labels with a mixture of warm water and mild detergent. Or, touch residue with the sticky side of the tape or label.

•Before moving the dryer, place a strip of cardboard or thin fiberboard under the front leveling legs to prevent damage to floor.

Common Drying Problems

Many drying problems involve poor cleaning results, poor soil and stain removal, residues of lint and scum, and fabric damage. For satisfactory drying results, follow these suggestions provided by The Soap and Detergent Association.

PROBLEM POSSIBLECAUSES SOLUTIONS PREVENTIVEMEASURES

Greasy, oily	• Fabric softener sheet.	• Rub fabric softener stains with bar soap.
stains		Rinse and rewash.

•Add a few bath towels to small loads for proper tumbling.

•Some "silk-like" fabrics should be air dried.

•Use proper drying temperature.

•Place fabric softener sheet on top of load before starting the dryer.

Lint	•	Overloading.	•	Reduce load size and rewash using liquid	•	Do not overload dryer.
	•	Overdrying causes static		fabric softener in the final rinse.	•	Use fabric softener in washer or dryer to
		electricity.	•	Or, add a fabric softener sheet and tumble		reduce static electricity.
	•	Lint screen not clean when		without heat.	•	Remove items when they are slightly damp to
		cycle began.	•	Use lint brush or roller to remove lint.		avoid overdrying.
	•	Lint is attached to "pills."			•	Check that lint screen is clean and in place.
Pilling	•	Pilling is normal with	•	Use a lint brush or shaver to remove pills.	•	Use fabric softener to lubricate fibers.
(Fibers break	off,	synthetic and permanent			•	When ironing, use spray starch or fabric finish
ball up and cling		press fabrics. This is due to				on collars and cuffs.
to fabric.)		abrasion from normal wear.			•	Turn items inside out to reduce abrasion.
Shrinking	•	Overdrying.	•	Irreversible condition.	•	Follow fabric care label directions.
					•	If shrinking is a concern, check load often.
					•	Remove items while slightly damp and hang or
						lay flat to complete drying.
					•	Block knits into shape.

Wrinkling	•	Overloading.
	•	Leaving items in dryer after
		cycle ends.

•Reduce load size and tumble at medium or low heat for 5-10 minutes.

•Remove items immediately. Hang or fold.

•Do not overload dryer.

•Remove items as soon as cycle ends.

4