AEG 40360 I Leak Prevention System, Electrical connection, Appliance is automatically pumped out

Page 33

Installation and Connection Instructions

 

Leak Prevention System

 

For protection from damage due to water leaks, the dishwasher is

 

equipped with a leak prevention system, the AQUA CONTROL SYSTEM.

 

In the event of a fault, the safety valve immediately interrupts the sup-

 

ply of water to the appliance and the drain pump switches on. By this

 

means water can neither escape nor overflow. The remaining water in

 

the appliance is automatically pumped out.

1

The AQUA CONTROL SYSTEM also works when the appliance is switched

 

off – the appliance must however not be disconnected from the mains.

Electrical connection

1

In compliance with electric company technical requirements for mains

 

connections, hard-wired connections to the mains may only be made

by approved electri-cians.

When connecting the appliance, observe the German VDE regulations and, if applicable, any additional conditions required by your local elec- tricity supplier. Following installation, live parts and live insulated wir- ing must not be accessible using a finger test in accordance with EN 60335/DIN VDE 0700.

Information on the electrical connection can be found on the rating plate on the right side of the inner edge of the dishwasher door. If the appliance has a change-over switch, the additional instructions on the change-over diagram in the mains connector box must be observed.

Prior to connecting ensure that the mains voltage and current rating at the site of installation match the nominal voltage and current rating given on the rating plate. The required fuse protection is also to be found on the rating plate.

To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.

If the appliance is hard-wired to the mains supply, then it must be safely isolated from the mains within the electrical installation with switches intended to ensure all-pole(N,L1)disconnection, shall be directly connected to the supply terminals and shall have a contact separation (fuses, cut outs, current trips or similar) of at least 3mm in each pole.

33

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Favorit 40360 Dear customer Tips on using the appliancePlease read these user instructions carefully Use of the appliance are marked with a clover leafContents Installation and Connection Instructions Safety Instructions Installation, Connection and Placing into OperationChild Safety Correct Use General SafetyEconomical and Ecological Dishwashing DisposalDisposing of the Packaging Material Disposal of old appliancesAppliance Features and Control Panel Control Panel Prior to using for the first timeYour area Adjusting the Water SoftenerFilling with Special Salt for the Water Softener Prior to using the dishwasher for the first timeFill with special salt Place the funnel supplied on the con- tainer openingThat you glasses are clear Filling with Rinse AidWould damage the appliance Fill with rinse aidAdjusting Rinse Aid Dosing Daily Use Loading cutlery and dishesNot be washed in the dishwasher Long, pointed items of cutlery Loading CutleryCutlery rack are a hazard, particularly Place the grid insert on the cutlery rackLoad large and heavily soiled dishes in the lower rack Loading Pans, Frying Pans and Large PlatesLoading Cups, Glasses Coffee Services Fill with detergent Filling with DetergentBio Wash Programmes and Concentrated Detergents Type of Soiling Selecting the Wash Programme Programme TableChanging/Interrupting the Wash Programme Starting the Wash ProgrammeProgramme again Changing the wash programmeSwitching Off the Dishwasher Emptying the DishwasherWasher Cleaning the Filter Care and CleaningPut the flat filter back in the base Washing compartment What to do, whenWash result is unsatisfactory There are problems with the operation of the dish- washerDishes are still dirty Wrong wash programme was selectedDishes are wet and dull Drain hose is incorrectly laidRinse aid was not used Rinse aid container is empty Decrease rinse aid dosingTechnical Data Upper basket Lower basket with cutlery basket Sample loading arrangementsInstalling the Dishwasher Installation and Connection InstructionsSee installation template supplied With the following dimensionsDishwashers That Can Be Integrated Water Connection Connecting the DishwasherPermitted water pressure Connect the inlet hoseDrain hose Water drainExtension hoses Sink outlet connectionLeak Prevention System Electrical connectionAppliance is automatically pumped out Connections Belgium Service DepartmentsGuarantee Conditions Guarantee Conditions Page Service AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG

40360 I specifications

The AEG 40360 I is a sophisticated built-in microwave oven that has gained popularity for its innovative features, advanced technology, and user-friendly characteristics. Designed to effortlessly integrate into modern kitchens, it provides a convenient cooking solution without compromising on style or performance.

One of the standout features of the AEG 40360 I is its generous capacity, allowing users to accommodate larger dishes and family-sized meals. With a spacious interior, this microwave easily handles everything from reheating leftovers to cooking full courses, making it a versatile kitchen companion.

This model is equipped with advanced inverter technology, which ensures a consistent and even distribution of heat. Unlike traditional microwaves that operate on a simple on-and-off cycle, the inverter technology allows for precise temperature control, resulting in perfectly cooked meals without cold spots. This is especially beneficial for delicate foods such as fish or sauces that require careful attention.

Another remarkable characteristic of the AEG 40360 I is its multitude of auto-cook programs. These pre-set programs take the guesswork out of cooking, allowing users to simply select the type of food they are preparing, and the microwave adjusts the cooking time and power level automatically. This feature enhances the overall cooking experience by providing reliable results every time.

The user interface is intuitive and easy to use, featuring a clear digital display and simple controls. The microwave also incorporates a stainless-steel finish, contributing to a sleek and modern aesthetic that complements various kitchen designs. Additionally, the appliance's interior is designed for effortless cleaning, with a non-stick surface that resists stains and spills.

Safety is a key consideration in the design of the AEG 40360 I. It boasts a child lock feature that prevents accidental operation, making it a safe option for families with young children. Furthermore, its built-in ventilation system ensures that excess heat and steam are effectively managed, promoting a stable cooking environment.

In summary, the AEG 40360 I microwave combines style, efficiency, and safety features, making it an ideal addition to any kitchen. Its advanced technologies, such as inverter cooking and auto-cook programs, provide convenience and ensure high-quality results, setting a standard for modern cooking appliances. Whether for reheating, defrosting, or cooking, this microwave stands out as a reliable and attractive choice for culinary enthusiasts and busy households alike.
Top Page Image Contents