AEG 4070 Leak Prevention System, Electrical connection, Appliance is automatically pumped out

Page 35

Installation and Connection Instructions

 

Leak Prevention System

 

For protection from damage due to water leaks, the dishwasher is

 

equipped with a leak prevention system, the AQUA CONTROL SYSTEM.

 

In the event of a fault, the safety valve immediately interrupts the sup-

 

ply of water to the appliance and the drain pump switches on. By this

 

means water can neither escape nor overflow. The remaining water in

 

the appliance is automatically pumped out.

1

The AQUA CONTROL SYSTEM also works when the appliance is switched

 

off – the appliance must however not be disconnected from the mains.

Electrical connection

1

In compliance with electric company technical requirements for mains

 

connections, hard-wired connections to the mains may only be made

by approved electri-cians.

When connecting the appliance, observe the German VDE regulations and, if applicable, any additional conditions required by your local elec- tricity supplier. Following installation, live parts and live insulated wir- ing must not be accessible using a finger test in accordance with EN 60335/DIN VDE 0700.

Information on the electrical connection can be found on the rating plate on the right side of the inner edge of the dishwasher door. If the appliance has a change-over switch, the additional instructions on the change-over diagram in the mains connector box must be observed.

Prior to connecting ensure that the mains voltage and current rating at the site of installation match the nominal voltage and current rating given on the rating plate. The required fuse protection is also to be found on the rating plate.

To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.

If the appliance is hard-wired to the mains supply, then it must be safely isolated from the mains within the electrical installation with switches intended to ensure all-pole(N,L1)disconnection, shall be directly connected to the supply terminals and shall have a contact separation (fuses, cut outs, current trips or similar) of at least 3mm in each pole.

35

Image 35
Contents Ökofavorit Use of the appliance are marked with a clover leaf Tips on using the applianceDear customer Please read these user instructions carefullyContents Installation and Connection Instructions Child Safety Safety instructionsInstallation, connection and initial use Intended use General safetyPOM For polyoxymethylene, e.g. plastic clips DisposalDisposing of the Packaging Material Disposal of old appliancesEconomical and Ecological Dishwashing Appliance Features and Control Panel Control panel Prior to using for the first timeIndicators have the following meanings Hardness range of the water in your area Adjust the water softenerAdjust Number SaltTurning it anticlockwise Filling with Special Salt for the Water SoftenerFill with special salt Use special salt Open the door, remove the lower RackFill with rinse aid Filling with Rinse AidThat you glasses are clear Would damage the applianceAdjusting Rinse Aid Dosing For washing in the dishwasher the following cutlery/dishes Daily UseLoading cutlery and dishes Not be washed in the dishwasherLong, pointed items of cutlery Loading CutleryTo ease the loading of large items at Loading Pans, Frying Pans Large PlatesLoad large and heavily soiled dishes in the lower rack Loading Cups, Glasses and Coffee Services Fill with detergent Filling with DetergentBio Wash Programmes and Concentrated Detergents Selecting the Wash Programme Programme Table Changing the wash programme Changing/Interrupting/CancellingStart the wash programme Wash ProgrammeLoad Sensing Sensor Logic Emptying the Dishwasher Care and CleaningSwitching Off the Dishwasher Cleaning the Filter END and Drying on Error messages are displayedWhat to do, when Malfunction Possible Cause RemedyWrong wash programme was selected Problems occur during use of the dishwasherWash results are not satisfactory Dishes are still dirtyLower rinse aid dosing Technical DataDishes are wet and dull Rinse aid was not used Rinse aid container is emptyUpper basket Lower basket with cutlery basket Sample loading arrangementsInstalling the Dishwasher Installation and Connection InstructionsFree-Standing Appliances Dishwashers That Can Be IntegratedBuilt-In Dishwasher Fitted with a décor panel to match Plinth on free-standing appliances is not adjustableWork surface must be re-mounted Free-standing appliances can beConnect the inlet hose Connecting the DishwasherWater Connection Permitted water pressureSink outlet connection Water drainDrain hose Extension hosesAppliance is automatically pumped out Leak Prevention SystemElectrical connection Connections Croatia New Zealand E. Abu Dhabi Jordan MaltaEgypt Kanada Mauritius Australia Korea South NamibiaIsrael Malaysia Saudi Arabia Cyprus Lebanon OmanEstonia Latavia Poland Hongkong Lthuania RussiaSyria Thailand Slovakia Rep South AfricaHungary Otros puntos de Postventa en el extranjero Further after-sales service agencies overseasAutres agences étrangères assurant le service après-vente Weitere Kundendienststellen im AuslandPage Page Service AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG

4070 specifications

The AEG 4070 is an innovative appliance that brings together advanced technology and user-friendly features, tailored for the modern household. As part of AEG's esteemed line of household products, the 4070 showcases a blend of efficiency, performance, and design, making it a valuable addition to any kitchen or home.

One of the standout features of the AEG 4070 is its energy efficiency. Designed with sustainability in mind, this appliance is equipped with cutting-edge technology that minimizes energy consumption while maximizing performance. The Eco Mode is particularly noteworthy, allowing users to save on energy costs without compromising on results. This makes it an ideal choice for environmentally conscious consumers looking to reduce their carbon footprint.

In terms of functionality, the AEG 4070 is designed to handle a wide variety of tasks seamlessly. It features multiple cooking settings, enabling users to prepare everything from delicate dishes to hearty meals with ease. The precise temperature control ensures perfect results every time, helping home cooks achieve their culinary aspirations with confidence.

The design of the AEG 4070 is another key aspect that sets it apart. With a sleek and modern aesthetic, it easily complements various kitchen styles and enhances the overall appearance of the space. Its intuitive interface and easy-to-read display allow for effortless operation, ensuring that even novice cooks can use it effectively.

Moreover, the appliance incorporates advanced safety features that provide peace of mind during use. Overheat protection and automatic shut-off mechanisms are integral for ensuring safe operation, minimizing the risks associated with cooking.

Another remarkable technology within the AEG 4070 is its self-cleaning functionality. This feature not only saves time but also ensures that the appliance remains hygienic with minimal effort. By using high-temperature steam cleaning, the unit effectively eliminates any food residue and odors, making maintenance a breeze.

In summary, the AEG 4070 embodies the perfect balance of efficiency, convenience, and style. Its combination of state-of-the-art technologies, user-centric design, and eco-friendly features makes it a standout appliance in today’s competitive marketplace, appealing to a wide range of users from culinary enthusiasts to those seeking practical solutions for everyday cooking tasks.