Fitting the door handles

Installation 21

Install two spacers on the back side of the panel and two spacers with adhesive on the lower part.

(Example for right hinge performance)

The handles are supplied as a kit at delivery.

1.Screw the top handle bracket to the handle rod.

2.Fit the bottom handle bracket on the lower left-hand side of the door.

3.Fit the top handle bracket on the top left-hand side of the door.

4.Screw the handle rod to the bottom handle bracket.

Do not use excessive force and overtighten the screws (max. 2 Nm) as you may damage the door handles.

Connecting the water hose.

Water supply should be provided with a tap and 3/4" male connector within 1,5 m from the appliance.

This work is to be carried out by a skilled plumber.

There are different type-approved taps and tap assemblies on the market. The water hose must not be cracked, squeezed or put in tight bends.

Before the appliance is placed its final location, ensure that the water connection has been correctly carried out, that there is no leakage at the connection to the water tap.

Tighten the screw enough by hand.

Make sure that the gasket is properly positioned in the connector.

We recommend that the appliance is placed on a "run-off" mat intended for refrigerators and freezers, which makes it easier to detect possible leakage