Cecilware APT18WT Installation And Start-Upinstructions, For Airpot Brewer, Airpot Coffee Brewers

Airpot Coffee Brewers

SPECIFICATIONS AND OPERATION MANUAL

Electrical Specifications:

Model No.	Volts	Phase	Hz.	Watts	Amps	Receptacle	Circuit
						Nema No.	Breaker
APT18	120	1	50/60	1.8 Kw	15	5-15R	15
APT18WT	120	1	50/60	1.8 Kw	15	5-15R	15
APT100WT	120/240	1	50/60	5.0 Kw	23	L14-30R	30

Line cord included. “WT” with Water Tap, “X” for export.

NOTES: APT100 Model includes twist lock plug wired for 4 wire 120/240V including Neutral and

Ground.

(120V Models – available on special order and requires a 15amp circuit breaker.)

Water Connections: ¼” flared water inlet fitting and flare nuts for ¼” O.D. copper tubing with a minimum water pressure of 20 psi.

Dimensional Specifications:

MODEL	Width (Inches)	Depth (Inches)
APT18	8	17 1/4
APT100	16	17 1/4

Height (Inches)

251/2

251/2

INSTALLATION AND START-UP INSTRUCTIONS

FOR AIRPOT BREWER

Not Included with this Brewer unless ordered separately

2.2liter Airpot, Part No. V223A

Things to note when Brewing Coffee

•This brewer is set for 2.2 liter capacity Airpot.

•Volume can easily be adjusted for 1.9 liter or 2.5 liter Airpots.

WATER HOOK-UP (Check Local Plumbing Codes)

The National Sanitation Foundation (NSF®) requires the following for an NSF approved hook-up:

1.A quick disconnect water connection or enough extra coiled tubing (at least 2x the depth of the unit) so that it can be moved to clean underneath.

2.An approved back flow prevention device, such as a double check valve, must installed between brewer and water supply.

Water Connection:

APT Brewers are supplied with 1/4” flared water inlet fittings and flare nuts.

Use a 1/4” diameter copper tubing to connect brewer to a cold water supply line with a minimum water pressure of 20 psi.

HIGHLY RECOMMENDED: An external water supply shut-off valve near the brewer and a water purifier filter for better tasting fresh brewed coffee.

2