Panasonic NN-S254 Cleaning Vent Grille Oven Air Vent, Installing Vent Grille

Care and Cleaning of Your Microwave Oven (continued)

Cleaning Vent Grille (Oven Air Vent)

1.Moisten a soft cloth in hot water containing mild detergent and wipe gently as shown in Fig. A.

Do not use ammonia or a strong detergent.

(Fig. A)

Installing the replacement Charcoal Filter (NN-CF203)

This product is shipped for use in the top exhaust ventilation mode.

If you wish to install this product without using an exhaust duct, the exhaust must be recirculated through the front grille and the charcoal filter. This product is shipped with a standard charcoal filter already installed.

The Charcoal Filter cannot be cleaned and should be replaced periodically every 6 to 12 months, or more often if necessary. When necessary to replace the charcoal filter, it can be pur- chased from your local Panasonic dealer.

The part number of the replacement charcoal filter is NN- CF203, refer to the following instructions for replacement.

1.Remove the Vent Grille

Remove three screws from the top of Grille as shown in Fig. B. To remove Vent Grille, open the door, and pull the vent grille at the bottom, and tilt upwards.

Screws

(Fig. B)

2.Remove the Standard Charcoal Filter

Insert your finger under the bottom of the filter, and pull the Charcoal Filter forward as shown in Fig.C.

(Fig. C)

3.Install replacement Charcoal Filter (NN-CF203)

Install the Charcoal Filter aligning the two holes, then secure with two screws as shown in Fig. D.

Screw Screw

(Fig. D)

Installing Vent Grille

1.Align the tabs of Grille with the slots of top plate, and insert as shown in Fig. E.

Top Plate

Slot

Grille

(Fig. E)

2.Install the bottom of Grille so that the locking tabs hook into the slots of the steel plate as shown in Fig. F.

(Fig. F)

3. Replace three screws on the top of Grille as shown in Fig. B.

28