Sanyo TVQ-EXA089K service manual Unloading and Carpentry Procedures, NSF Certification, Location

3 Unloading and Carpentry Procedures

3.1NSF Certification

The merchandisers described in this manual are built to meet the requirements of American National Standard/NSF International Standard 7. Each merchandiser bears a nameplate identifying the type of application for which it was certified:

Type I display refrigerator / freezer: Intended for use in an area where the environmental conditions are controlled and maintained so that the ambient temperature typically does not exceed 75°F.

3.2Location

As noted above, the merchandisers described in this manual are design for the display of products in interior spaces with climate control, with ambient conditions typically maintained below 75°F and 55% relative humidity. Proper merchandiser performance cannot be guaranteed when ambient temperature and/or humidity exceeds this level.

Merchandisers should not be exposed to direct sunlight or other sources of heat.

Merchandisers should not be exposed to strong air currents, as these may disrupt the air curtain used to maintain proper temperature inside the merchandiser display area.

3.3Shipping Damage

All equipment should be examined for shipping damage prior to and during offloading. All equipment goes through outgoing inspection upon leaving our warehouse, and the carrier assumes responsibility for the safe arrival of our merchandisers.

APPARENT DAMAGE: Any obvious loss or damage should be noted immediately at the time of receipt on the freight bill or express receipt and signed by the carrier’s agent. Failure to do so may lead to rejection of the claim by the carrier.

CONCEALED DAMAGE: If damage that is not apparent during unloading is found after unpacking, retain all packing materials and submit a written request to the carrier for inspection within 15 days.

LOST ITEMS: Any claims related to lost or missing items must be made to SANYO Commercial Solutions within 48 hours of receipt of equipment.

3.4Unloading Instructions & Precautions

WARNING

Cases are heavy and bulky, and require at least two people for unloading, moving, and installation.

8-ft and 12-ft merchandisers have wooden beams mounted on each side (no beams on end cases). Do not remove the wooden beam from the bottom edges of each case until the cases have been moved into place in the store lineup.

Do not walk on the top of the merchandisers. Walking on the top of the merchandiser may lead to serious injury and/or damage to the merchandiser. Do not place other heavy loads on the top of the merchandiser.

Recommended Practices for Unloading Merchandisers:

1.Use a J-bar (Johnson bar) to lift one end of the merchandiser.

2.Insert one or more dollies under the base leg.

3.Lift the other side with the J-bar.

4.(Optional) Insert one or more dollies.

5.Move merchandiser out of container.

6.Use dollies on both ends of the merchandiser to move to lineup location after unloading from container.

7