Cleaning
Cleaning Guidelines
Caution
Always turn off electrical power at the mains supply before commencing cleaning.
This oven is not water proof. Do not use water jet spray to clean interior or exterior of the appliance.
To achieve the best results, cleaning must be regular and thorough. If any small faults occur, have them looked at promptly. Don't wait until they cause a complete breakdown.
NOTE:
•Carefully read and follow the safety instructions on the label of the cleaning product to be used.
•DO NOT use harsh abrasive scouring pads or abrasive detergents as they could damage the oven.
•Ensure that any detergent or cleaning material has been completely removed after each cleaning.
To keep your oven clean and operating at peak efficiency, follow the procedures shown below:-
Oven Cleaning
NOTE:
•If the oven usage is very high, the cleaning procedure should be carried out on a more frequent basis.
•Allow the oven interior to cool to approx 50˚C - 120˚F before commencing cleaning.
Stainless Steel Surfaces
a.Thoroughly clean the exterior surfaces of the oven with, a damp cloth moistened with a mild detergent solution, or a soft bristled brush.
b.Baked on deposits or discolouration may require a good quality stainless steel cleaner. Always apply cleaner when the oven is cold and rub in the direction of the grain.
Side Racks
a.Remove wire oven racks and bottom element guard.
b.Partially undo the rack securing screw (anti- clockwise) securing side rack to the oven wall, until the rack is loose.
Rack Securing
Screw
Rear
Location
Points
c.Pull side racks forward to disengage the location pins at the rear of rack from the rear wall of the oven and remove the racks from the oven.
d.Clean all racks with a mild anti bacterial detergent and hot water, using a soft bristled brush.
e.Dry the racks thoroughly with a dry cloth.
f.To refit the racks, engage the locating pins at the rear of side rack into the locating holes in the rear of the oven.
g.At the same time locate the front of the rack over the rack securing screw and hand tighten the rack securing screw .
h.Refit the wire oven racks and bottom element guard to the oven.
Lamp Glass / Fan Baffle
a. Remove the wire racks as shown previously.
Lamp
Glass
Fan
Baffle
Location
Bracket
b.Whilst holding the fan baffle in place, undo the lamp glass
Unscrew
c.Pull the fan baffle forward off the location bracket at lower rear of the oven.
d.Clean fan baffle with mild anti bacterial detergent and hot water solution using a soft bristled brush.
e.Dry fan baffle thoroughly with a soft dry cloth before
f.Clean the lamp glass using a soft cloth with a mild anti bacterial detergent and hot water solution.
g.Dry the lamp glass thoroughly with a dry cloth.
h.Refit the fan baffle onto the location bracket below the fan.
i.Whilst holding the fan baffle in place, refit the lamp glass, screw the glass in clockwise to secure the fan baffle in place. Do not over tighten lamp glass.
12