INSTALLATION INSTRUCTIONS
Install the
Before operating this unit, be sure that the following two components are properly installed:
1.The reflector tray is installed below the lower heating elements before shipping. It merely slides under the conveyor. NOTE: Proper toasting cannot be performed without reflector tray installed.
2.The toast receiving tray is packaged separately and must be installed before operating this unit. For front delivery position, slide the receiving tray into the toaster cavity below the control panel, making sure the lipped end is towards the back. Place the lipped end over the two (2) protruding pins located at the rear of the toaster cavity. For rear delivery position, slide the receiving tray into the cavity from the back of the toaster and place the lipped end over the 2 protruding pins closest to the front of the toaster (See Figure 1).
Use these two mounting pins for front delivery position.
Toast receiving tray in rear delivery position.
Toast receiving tray in front delivery position.
! WARNING !
This toaster must be plugged into the proper voltage which is specified on the data plate located on the back panel of the toaster. Use of any other voltage or altering of plug will damage unit, void warranty and may cause injury.
ELECTRICAL SPECIFICATIONS
| Voltage |
| Amperage |
| Max. Power |
| Frequency |
| Phase |
| (Volts AC) |
| (Amps) |
| (KW) |
| (HZ) |
| |
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
120 | 14.8 | 1.7 | 50/60 | 1 | |||||
208 | 12.5 | 2.4 | 50/60 | 1 | |||||
220 | 9.6 | 2.1 | 50/60 | 1 | |||||
240 | 10.4 | 2.4 | 50/60 | 1 | |||||
| *220 |
| 9.6 |
| 2.1 |
| 50/60 |
| 1 |
| *240 |
| 10.4 |
| 2.4 |
| 50/60 |
| 1 |
|
|
|
|
|
|
|
|
|
|
Cord
(Attached)
3’
3’
3’
3’
3’
3’
Plug
(Attached)
NEMA 5-15P
NEMA 6-15P
NEMA
NEMA
None
None
The circuit on which the receptacle is installed must be of adequate wiring size and sufficient capacity to meet the requirements indicated on the unit data plate and in accordance with the National Electrical Code and local electrical installation codes. * The 220V electrical information in the shaded area pertains to European models. The 240V electrical information in the shaded area pertains to United Kingdom models.
3 |