Temperature setting
•Unlock the control panel by pressing the 
pad for approximately 3 seconds. Once the control panel is unlocked an audible beep will be heard and the 
indicator will go out.
•Under normal conditions the temperature display indicates the current temperature of the corresponding zone. When adjusting the temperature, the temperature display will flash to indicate that the temperature is being adjusted.
•The temperature in both upper zone and lower zone can be set independently by pressing
(warmer) or 
(colder) pads that correspond to desired zone. The temperature range of both zones can be set between 39°F to 61°F (4° to 16°) +/- 5°F.
•When the pad 
(warmer) or 
(colder) is pressed, the temperature displayed will increase or decrease in an increment of one degree. If the pad 
(warmer) or 
(colder) is pressed and held for 2 seconds, the temperature displayed will increase or decrease in a speed of one degree per half second.
•Once you have adjusted the upper or lower zone to the desired temperature, release the temperature pad. At this time the temperature displayed will flash for approximately 3 seconds to confirm the selected temperature. Once the display stops flashing the temperature display will indicate the current temperature of that zone.
Note:
The temperature display can be changed between Celsius and Fahrenheit by simultaneously
pressing and holding both pads 
(warmer) and 
(colder) for the upper zone for approximately 3 seconds. This unit cannot be in 
(Lock) mode to perform this operation.
Interior Light
To turn on / off the interior light, press the 
(Light) pad. The unit cannot be in the 
(Lock) mode to perform this operation. Note: The light will turn on / off after the touch pad is released.
AUTOMATIC DEFROST
There is no need for manual defrosting of this appliance due to automatic defrosting function.
•The ice
•When defrosting is in process, the indicators 
for both zones will go off, and the circulation fans for both zones will run.
•Defrost water will drain out passing through the drain outlet in the inner back wall into a drain pan located above the compressor, from where it evaporates.
7 | EN |