Brewing with Pre-ground Coffee Beans

4.Place the permanent filter in the filter compartment and close the filter cover. Push the filter compartment in place.

NOTE: A permanent filter may allow some ground coffee to flow into carafe.

5.Close the water reservoir cover by pressing down until it locks; the appliance is equipped with a safety interlock system.

CAUTION: The appliance will not turn on if the water reservoir cover is not closed properly or the grinder box is not installed properly. Press ON/OFF button to continue brewing.

6.Plug the cord into an electrical outlet; “88:88” will display and flash on the LED. After 5 seconds, “12:00” will display. Set the clock as instructed in Setting the Clock above.

7.For immediate grinding and brewing, press the ON/OFF button. RUN indicator will turn on and the Coffee Maker will start brewing.

NOTE: When GRIND OFF indicator is on, the Coffee Maker will make coffee with pre- ground beans.

8.Choose the grinding amount of beans by pressing the 1-4CUP button or using the default setting of 5 to 12 cups.

NOTE: 1-4CUP setting runs for 30 seconds. 5-12CUP default setting runs for 40 seconds.

9.Brewing will start after grinding is completed.

CAUTION: Be cautious with the steam during the brewing process.

10.When the brewed coffee is ready, stirring is recommended for blending flavors. The coffee will be kept warm for 2 hours before the Coffee Maker shuts off automatically.

1.Open the water reservoir by pushing the release button and lifting it up. Make sure the inner cover is in place and pour the desired amount of water in the reservoir by referencing the water level marks on the right side of the reservoir.

2.Pull out the filter compartment and add pre-ground coffee in the permanent filter.

CAUTION: The maximum capacity for ground coffee is 10 scoops using a permanent filter.

3.Replace the filter cover and push the filter compartment in place.

4.Before brewing coffee, make sure the carafe is properly positioned on the warming plate and the filter compartment setup properly.

5.Plug the cord into an electrical outlet; “88:88” will display and flash on the LED. After 5 seconds, “12:00” will display before setting the clock. See Setting the Clock above.

6.Press the GRIND OFF button until the indicator turns on. Press ON/OFF button to begin brewing without using the grinder.