Samsung MW102W manual Installing Your Microwave oven Setting the Time

Installing Your Microwave oven Setting the Time

Place the oven on a flat, level surface that strong enough to safely bear the weight of the oven.

20cm	10cm	1.	When you install your oven, make sure there is adequate
above	behind		ventilation for your oven by leaving at least 10 cm (4
			inches) of space behind and, on the sides of the oven
	10cm		and 20 cm (8 inches) of space above.
	of the side

2.Remove all packing materials inside the oven. Install the roller ring and turntable.

Check that the turntable rotates freely.

3.This microwave oven has to be positioned so that plug is accessible.

☛Never block the air vents as the oven may overheat and automatically switch itself off. It will remain inoperable until it has cooled sufficiently.

☛For your personal safety, plug the cable into a 3-pin, 220 Volt, 50Hz, AC earthed socket. If the power cable of this appliance is damaged, it must be replaced by a special cable (I-SHENG SP022, KDK KKP4819D, EUROELECTRIC 3410, SAMIL SP- 106B, MOONSUNG EP-48E, HIGH PROJECT H.P 3). Contact your local dealer to have it replaced. The power cable of ISRAEL is PENCON(ZD16A), S/AFRICA APEX LEADS SA16 and NIGERIA, GHANA, KENYA and U.A.E is PENCON(UD13A1).

☛Do not install the microwave oven in hot or damp surroundings like next to a traditional oven or radiator. The power supply specifications of the oven must be respected and any extension cable used must be of the same standard as the power cable supplied with the oven. Wipe the interior and the door seal with a damp cloth before using your microwave oven for the first time.

Your microwave oven has an inbuilt clock. The time can be displayed in either the 24-hour or 12-hour notation. You must set the clock:

•When you first install your microwave oven

•After a power failure

✉Do not forget to reset the clock when you switch to and from summer or winter time.

1. To display the time in the..Then press the		button...
24-hour notation	Once
12-hour notation	Twice

2. Turn the Time/Weight( ) dial to set the hour.

3.Press the button.

4. Turn the Time/Weight( ) dial to set the minute.

5.Press the button.

GB

5