Bunn 2 manual Introduction, Contents, BUNN-O-MATIC Commercial Product Warranty

Page 2

INTRODUCTION

This equipment dispenses granita-type and cold liquid drinks on demand from separate hoppers. Operating controls are accessible only through password protection.

CONTENTS

Introduction & Warranty

2

User Notices

3

Site Preparation, Electrical Requirements

3

Initial Setup

4

Operating Controls

6

Programming

7

Using the Dispenser for Granita-Type Products

24

Using the Dispenser for Cold Liquid Products

24

Other Recommendations For Your Dispenser

25

Recommended Daily Cleaning

26

Auto-fill Cleaning Instructions

28

Required Regular Maintenance

29

Schematic Wiring Diagrams

31

BUNN-O-MATIC COMMERCIAL PRODUCT WARRANTY

Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows:

1)All equipment other than as specified below: 2 years parts and 1 year labor.

2)Electronic circuit and/or control boards: parts and labor for 3 years.

3)Compressors on refrigeration equipment: 5 years parts and 1 year labor.

4)Grinding burrs on coffee grinding equipment to grind coffee to meet original factory screen sieve analysis: parts and labor for 3 years or 30,000 pounds of coffee, whichever comes first.

These warranty periods run from the date of installation BUNN warrants that the equipment manufactured by it will be commercially free of defects in material and workmanship existing at the time of manufacture and appearing within the applicable warranty period. This warranty does not apply to any equipment, component or part that was not manufactured by BUNN or that, in BUNN’s judgment, has been affected by misuse, neglect, alteration, improper installation or operation, improper maintenance or repair, damage or casualty. This warranty is conditioned on the Buyer 1) giving BUNN prompt notice of any claim to be made under this warranty by telephone at (217) 529-6601 or by writing to Post Office Box 3227, Springfield, Illinois 62708-3227; 2) if requested by BUNN, shipping the defective equipment prepaid to an authorized BUNN service location; and 3) receiving prior authorization from BUNN that the defective equipment is under warranty.

THE FOREGOING WARRANTY IS EXCLUSIVE AND IS IN LIEU OF ANY OTHER WARRANTY, WRITTEN OR ORAL, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF EITHER MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. The agents, dealers or employees of BUNN are not authorized to make modifications to this warranty or to make additional warranties that are binding on BUNN. Accordingly, statements by such individuals, whether oral or written, do not constitute warranties and should not be relied upon.

If BUNN determines in its sole discretion that the equipment does not conform to the warranty, BUNN, at its exclusive option while the equipment is under warranty, shall either 1) provide at no charge replacement parts and/or labor (during the applicable parts and labor warranty periods specified above) to repair the defective components, provided that this repair is done by a BUNN Authorized Service Representative; or 2) shall replace the equipment or refund the purchase price for the equipment.

THE BUYER’S REMEDY AGAINST BUNN FOR THE BREACH OF ANY OBLIGATION ARISING OUT OF THE SALE OF THIS EQUIPMENT, WHETHER DERIVED FROM WARRANTY OR OTHERWISE, SHALL BE LIMITED, AT BUNN’S SOLE OPTION AS SPECIFIED HEREIN, TO REPAIR, REPLACEMENT OR REFUND.

In no event shall BUNN be liable for any other damage or loss, including, but not limited to, lost profits, lost sales, loss of use of equipment, claims of Buyer’s customers, cost of capital, cost of down time, cost of substitute equipment, facilities or services, or any other special, incidental or consequential damages.

2

32080.0001 120105

 

Image 2
Contents ULTRA-2 Introduction ContentsBUNN-O-MATIC Commercial Product Warranty 29979.0000 User Notices29947.0000 00986.0002On top of the motor covers Platform. Retighten motor Initial SetupInstall support rod into hole Cover screws Assemble the drip tray Operating Controls Programming Switches ProgrammingOff ULTR027930 AN000001 104530 AMJAN JAN Off offMenu Function Index Cleaning Guide ? No YES Please WaitSET Thickness ? No YES MIN Left 9 MAX MIN Right 5 MAX SET Date Time ? No YES Test Augers ? Left Auger Test YESLeft Auger Test Next OFF Next Reverse Test AugersPassword 0 Next + SET Language ? No YESOFF + Night Time Mode Chill ChillSET Night Time SET DAY Time Defrost Minutes OFF + Freeze MinutesPM Complete ? No YES Month PM on +Next + DAY to Clean OFFClean Lockout Modify Message ? No YESYES Thick Adjust No Thick Adjust On + Lockout + SwitchesSwitches Enabled Refill Disabled + Enabled + AD MessageSET Pass WR Enter Asset #AN000000 Next Next +Ultra Install DateAre YOU Sure ? 67 h Temp & Torque mode is typically used for serviceDisplay Temp & Torque Using the Dispenser for GRANITA-TYPE Products Using the Dispenser for Cold Liquid ProductsOther Recommendations for Your Dispenser Recommended Daily Cleaning Auger nose InstallationPlace as shown So the flat face of the auger Turn spring in the faucet valveAuto-fill Cleaning Instructions With Brixing Pump Installed 27446.0000 InstructionsInventory this kit for completeness before proceeding 26781.0000Remove and clean condenser air filter. See FIG Required Regular MainenanceSchematic Wiring Diagram ULTRA-2 Schematic Wiring Diagram ULTRA-2A Late Model Dispensers Schematic Wiring Diagram ULTRA-2A
Related manuals
Manual 24 pages 30.11 Kb Manual 3 pages 44.87 Kb

2 specifications

The Bunn 2 is a renowned piece of coffee brewing equipment that has established itself as a favorite among coffee enthusiasts and commercial establishments alike. Known for its efficiency and reliability, the Bunn 2 offers a range of features and technologies that cater to both casual brewers and professional baristas.

One of the standout features of the Bunn 2 is its innovative brewing technology. It utilizes a patented brewing system that allows for a consistent and precise brew temperature, which is crucial for extracting the rich flavors of coffee beans. The machine’s water reservoir heats water to the optimal brewing temperature, ensuring that every cup is brewed to perfection. This technology helps to enhance the coffee's aroma and flavor profile, making each sip a delightful experience.

Another prominent feature of the Bunn 2 is its impressive brewing capacity. Designed with a high-volume brewing process in mind, it can produce multiple pots of coffee in a short amount of time. This is particularly beneficial for settings such as offices, cafés, and restaurants where demand for coffee can peak at various times throughout the day. The fast-brewing capability means customers and staff don’t have to wait long for their caffeine fix, making it a practical choice for busy environments.

The design of the Bunn 2 is both functional and user-friendly. The machine typically includes features like a easy-to-read water level indicator, making it simple to monitor the water supply. Moreover, the intuitive control panel allows users to customize brew settings, such as brew strength and volume, ensuring that every brew meets individual preferences.

Durability is another key characteristic of the Bunn 2. Constructed from high-quality materials, this coffee maker is built to withstand the rigors of daily use. Whether in a home kitchen or a high-traffic café, the Bunn 2 is designed to deliver reliable performance over time.

Additionally, Bunn emphasizes ease of cleaning and maintenance. Many models include removable components that simplify regular upkeep and minimize the hassle associated with maintaining coffee equipment.

In summary, the Bunn 2 combines innovative brewing technology, high-volume capacity, user-friendly design, and durability, making it a top choice for anyone passionate about great coffee. Its features and characteristics cater to a wide range of users, ensuring that high-quality coffee is always just a brew away. Whether you are starting your day at home or serving customers in a café, the Bunn 2 promises an exceptional coffee experience.