Bunn ULTRA-2 manual Recommended Daily Cleaning

Page 20

RECOMMENDED DAILY CLEANING

NOTE – Turn the power OFF to the dispenser before proceeding.

1.Empty all product from the hoppers. Disconnect the hopper lid lamp cords and remove the lids.

2. Depress the hopper lock 3. Pull forward to remove.

4. Pull the auger from the cooling

plunger. Lift the hopper up

drum.

slightly.

 

5. Remove the cooling drum seal 6.

Caution: The faucet valve is 7.

Carefully slide the faucet valve

from the rear of the drum.

under spring tension. Spread

up to remove the spring and

 

one side of the handle first, then

faucet seal. Extra care should

 

the other and disconnect from

be taken when handling the seal

 

the hopper.

to prevent damage. Do not fold

 

 

the seal as this will cause dam-

 

 

age to the Teflon® sealing sur-

 

 

face.

8. Remove the auger nose bushing 9.

Care must be taken to ensure this surface does not get scratched during

from inside the hopper.

cleaning. Deep scratches could cause leakage around the seal.

10.Place all parts in a clean sink with mild hot water (120°F) and sanitizer solution. Allow all parts to soak for at least 5 minutes. Carefully wash all components with a clean wash cloth in the hot water and sanitizer solution. Use a clean, soft bristle brush as needed for the smaller components and tight areas. Do not immerse hopper lids. Use a commercial sanitizer that has 100 ppm of available chlorine with a concentration level of at least 3% available chlorine (KAY-5 Sanitizer). Follow the sanitizer’s mixing instructions to ensure 100 ppm of available chlorine.

11.Wash the drums, hopper drip trays, top covers, and outer enclosure using a clean wash cloth that has been dampened in the hot water and sanitizer solution. Pay particular attention to the shaft area and make sure it is thoroughly cleaned and sanitized.

12.Thoroughly rinse all surfaces with a clean wash cloth that has been dampened with hot water. Wipe dry with a clean dry wash cloth before reassembling the dispenser.

NOTE – Although most parts are dishwasher safe, they may be affected by the chemicals in some commercial sanitizing agents. Do not place the hopper nor hopper lids in a dishwasher. Rinse thoroughly before assembly.

20

32080 032702

 

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Bunn ULTRA-2 Introduction ContentsBUNN-O-MATIC Commercial Product Warranty 29947.0000 User Notices00986.0002 On top of the motor covers Platform. Retighten motor Initial SetupInstall support rod into hole Cover screws Assemble the drip tray Operating Controls Programming Switches Programming104530 AM JANOff ULT00000001 AN00000001 JAN Off OffCleaning Guide No YES Please WaitSET Thickness ? No YES MIN Left 9 MAX MIN Right 5 MAX Test Augers ? Left Auger Test YES Left Auger Test Next OFF Next ReverseSET Date Time ? No YES Test AugersPassword 0 Next + Night Time Mode Chill ChillSET Night Time SET DAY Time OFF +Defrost Minutes OFF + Freeze Minutes 60 +PM Complete ? No YES Month PM On +Clean Lockout YES Thick Adjust No Thick AdjustDay To Clean Off formerly Days....Disabled Next +Switches Switches EnabledOn + Lockout + SET Pass WRUltra Install DateAre YOU Sure ? 67 h Temp & Torque mode is typically used for serviceDisplay Temp & Torque Using the Dispenser for GRANITA-TYPE Products Using the Dispenser for Cold Liquid ProductsOther Recommendations for Your Dispenser Recommended Daily Cleaning Installation Place as shown So the flat face of the augerAuger nose Turn spring in the faucet valveSchematic Wiring Diagram ULTRA-2 Schematic Wiring Diagram ULTRA-2A
Related manuals
Manual 68 pages 12.24 Kb Manual 19 pages 61.15 Kb

ULTRA-2 specifications

The Bunn ULTRA-2 is an exceptional frozen beverage dispenser that caters to both commercial and home use, making it a popular choice in various establishments such as cafes, restaurants, and convenience stores. Renowned for its reliability and efficiency, the ULTRA-2 serves a wide range of frozen beverages, including slushes, smoothies, and frozen cocktails, providing an irresistible treat for customers.

One of the standout features of the Bunn ULTRA-2 is its high-capacity design. With a dual hopper system, this machine allows operators to serve two different flavors simultaneously. Each hopper can hold up to 3.2 gallons of product, allowing for continuous service without the need for frequent refills. This is particularly advantageous during peak hours when demand is high.

The ULTRA-2 is equipped with Bunn's advanced refrigeration technology, which ensures rapid freezing and consistent product quality. The machine uses a patented freezing mechanism that maintains optimal product texture and temperature, resulting in a smooth, uniform consistency that keeps customers coming back for more. Additionally, the ULTRA-2's adjustable temperature control allows operators to customize the consistency of the beverages to their liking.

User-friendliness is another hallmark of the Bunn ULTRA-2. The machine features intuitive controls that simplify operation, making it easy for staff to learn and use efficiently. A built-in safety feature prevents the machine from operating when the hoppers are too low, minimizing waste and ensuring product quality.

Durability and ease of maintenance are also prominent characteristics of the ULTRA-2. Constructed from high-quality stainless steel, the machine offers enhanced longevity and is resistant to rust and corrosion. The removable hoppers and door assemblies facilitate quick cleaning and maintenance, allowing businesses to keep the machine in top working condition with minimal effort.

In summary, the Bunn ULTRA-2 stands out in the crowded market of frozen beverage dispensers through its dual hopper functionality, advanced refrigeration technology, user-friendly design, and robust construction. Whether for a busy café or a family gathering, the ULTRA-2 provides a reliable solution for delivering delicious frozen beverages that satisfy a variety of tastes and preferences.
Top Page Image Contents