Bunn G9T HD service manual User Notices, Contents, Introduction

Page 3

CONTENTS

Introduction----------------------------------------------------

3

User Notices----------------------------------------------------

3

Electrical Requirements---------------------------------------

4

CE Requirements----------------------------------------------

4

Initial Set Up----------------------------------------------------

4

Operating Controls---------------------------------------------

4

Cleaning---------------------------------------------------------

5

Preventive Maintenance---------------------------------------

5

Coffee Grinding------------------------------------------------

6

Adjustments----------------------------------------------------

6

INTRODUCTION

This equipment will store up-to nine pounds of whole bean coffee and grind it to a preset grind and amount into an awaiting funnel and filter from most commercial drip coffee brewers. The equipment is only for indoor use on a sturdy counter or shelf. Adequate space must be available above the grinder to raise the lid when adding beans. Use only with whole bean coffee.

The grind is preset at the factory to drip specifications as set forth by the United States Department of Commerce and adopted by the Coffee Brewing Center of the Pan American Coffee Bureau. Adjustments may be made to alter both the amount and grind from the factory setting.

USER NOTICES

Carefully read and follow all notices on the grinder and in this manual. They were written for your protection. All notices on the grinder are to be kept in good condition. Replace any unreadable or damaged labels.

#37881.0000

PERSONAL INJURY

HAZARD.

KEEP FINGERS AND FOREIGN OBJECTS OUT OF HOPPER OR CHUTE OPENING.

#05876.0000

WARNING

Use only on a properly protected circuit capable of the rated load.

Electrically ground the chassis. Follow national/local electrical codes. Do not use near combustibles.

An extension cord, when used, must be shorter than 20 feet if 16-gage 3-conductor wire, or shorter than 10 feet if 18-gage 3-conductor wire.

FAILURE TO COMPLY RISKS EQUIPMENT DAMAGE, FIRE, OR SHOCK HAZARD

READ THE ENTIRE OPERATING MANUAL INCLUDING THE LIMIT OF WARRANTY AND LIABILITY BEFORE BUYING OR USING THIS PRODUCT

20545-0000D 01/04 © 1990 Bunn-O-Matic Corporation

#20545.0000

00824.0002

Page 3

10171 040612

 

Image 3
Contents Phone 217 529-6601 FAX 217 G9 HD G9T HDBUNN-O-MATIC Commercial Product Warranty Contents User NoticesIntroduction Operating Controls Initial SET UPElectrical Requirements CE RequirementsYear CleaningPreventive Maintenance MonthAdjustments Burr AdjustmentCoffee Grinding Hash mark settings. Refer to Adjustment-Burr section Approximate Timer Settings in SecondsAdjustments Burr Adjustment Timer Adjustment