BUNN Espress™
FEATURES
Model ES•1A™
Chassis
The chassis of the ES•1A™ is made of painted steel and the work tray is stainless steel. To reach the interior of the machine, proceed as follows:
•Remove the cup heater tray (1)
•Loosen the two screws (2) holding the side panel in place (2)
•Remove the side panel (3) by lifting it up carefully.
•By loosening the nut (4) that holds the control panel in position and by placing the front piece at a right angle, access to the interior of the control panel is obtained.
•Finally, by removing the work tray (5) and the drainage tray (6), access is gained to all the elements of the machine.
2 | 4 | 1 |
3
|
| 6 |
|
|
| 5 |
|
|
|
| |
Technical features |
|
|
|
Width | 400 mm(15.7 inches) | Drainage | 25 mm (1.07 in) |
Height | 370 mm(14.5 inches) | Total brewer power .... | 2000 W. |
Depth | 490 mm(19.3 inches) | Electric feed | 120 V. Single phase |
Net weight | 30 kgs(66.12 lbs.) | Consumption | 16.7 A. |
Gross weight | 37 kgs(81.55 lbs.) | Boiler capacity | 4.0 liters (1.05 gal) |
Hydraulic feed |
|
|
6