Bunn TCD - 1/2 manual Faucet Under Pressure

INTRODUCTION

These dispensers are designed to mix liquid tea concentrate with water to produce iced tea by the glass or pitcher. The concentrate can be stored either inside the dispenser, or outside with a hose connection to the dispenser. The dispenser must be placed on a sturdy counter or shelf.

PLUMBING REQUIREMENTS

This dispenser must be connected to a cold water system with operating pressure between 30 and 90 psi (138 and 620 kPa) from a 1⁄2" or larger supply line. A shut-off valve should be installed in the line before the dispenser. The water inlet fitting is 1/4" flare.

NOTE - Bunn-O-Matic recommends 1/4" copper (or 3/8" braided flex) tubing for all installations from the 1⁄2" water supply line. A tight coil of copper tubing in the water line will facilitate moving the dispenser to clean the counter top. Bunn-O-Matic does not recommend the use of a saddle valve to install the dispenser. The size and shape of the hole made in the supply line by this type of device may restrict water flow.

As directed in the International Plumbing Code of the International Code Council and the Food Code Manual of the Food and Drug Administration (FDA), this equipment must be installed with adequate backflow prevention to comply with federal, state and local codes. For models installed outside the U.S.A., you must comply with the applicable Plumbing /Sanitation Code for your area.

USER NOTICES

Carefully read and follow all notices in this manual and on the equipment. All labels on the equipment should be kept in good condition. Replace any unreadable or damaged labels.

As directed in the International Plumbing Code of the International Code Council and the Food Code Manual of the Food and Drug Administration (FDA), this equipment must be installed with adequate backflow prevention to comply with federal, state and local codes. For models installed outside the U.S.A., you must comply with the applicable Plumb- ing /Sanitation Code for your area.

00656.0001

WARNING

FAUCET UNDER PRESSURE

Shut off water before cleaning. Use only BUNN approved faucet part #03260.0004 (Plastic Body Faucet, Locking Handle), #03260.0009 (Plastic Body Faucet, Non-Locking Handle) or #03260.0005 (Chrome Body Faucet), specifically designed for this equipment. Close the water valve at night or when not in use.

38130.0000D 07/07 © 2005 Bunn-O-Matic Corporation

38130.0000

PRESSURE REGULATOR ADJUSTMENT

1.Pull Knob out to unlock.

2.Adjust to 20 psi while faucet is open, dispensing product.

3.Push knob in to lock.

38465.0000

C

L

O

S

E

OPEN

38466.0000

3 34106.1 120910