Coleman 9770, 9775 manual English-6, Stove Set Up, To Fill Tank Coleman Fuel Bottle

3 Stove Set Up

NOTE: The reflector disc and windscreen are not illustrated in the set up instructions. This is so the features of the stove may be clearly visible and identified. Read about the reflector disc and windscreen in Sections 1 and 15.

■Unfold stove legs to detent stops and place on reflector disc. (Fig. 3, 4, and 5)

FIG. 3 FIG. 4 FIG. 5

4 To Fill Tank (Coleman® Fuel Bottle)

NEVER FILL OR LIGHT STOVE INSIDE HOUSE, CAMPER, OR TENT.

■Unscrew bottle from black pump assembly (Fig. 6 and 7).

FIG. 6 FIG. 7

■Use a funnel or suitable filling device and fill with clean, fresh Coleman® fuel.

■Fill bottle no more than 2/3 full (16 Fl. Oz.). Overfilling can result in fuel leakage and flare up during lighting. Your index finger can be used to check the fuel level. Insert index finger into fuel bottle as shown in Figure 9. If finger touches fuel, the bottle is too full. Pour out small amount of fuel until bottle is at the proper level. (Fig. 8)

■Make sure FUEL VALVE is fully “OFF” . (Fig. 10)

■Check “O” Ring for damage and carefully insert black pump assembly into fuel bottle and hand tighten. (Fig. 11)

■Replace FUEL CAP on fuel container. Tighten firmly. Move fuel container away from stove. WIPE UP ANY SPILLED FUEL AND DISPOSE OF IN A SAFE PLACE.

BLACK PUMP ASSEMBLY

OFF

“O” RING

BOTTLE

		FUEL VALVE
		FIG. 10
FIG. 8	FIG. 9		FIG. 11

English-6