oTurn the cold and hot water switches ON (at the rear). o Now you are ready to use your water dispenser.
IT WILL TAKE APPROXIMATELY 1 HOUR TO REACH OPTIMUM TEMPERATURE. IF YOU CONSUME ONE 8 OZ. CUP, THE RECOVERY TIME IS APPROXIMATELY 25 MINUTES OR LESS. IF YOU CONSUME 2 OR MORE 8 OZ. CUPS, RECOVERY TIME CAN TAKE UP TO 1 HOUR.
NOTE: Your water dispenser has been cleaned and sanitized before leaving the factory, but in case a taste problem develops, place one tablespoon of baking soda and add tap water. Fill water tank again and repeat basic operations previously outlined.
OPERATING YOUR WATER DISPENSER
Electrical Connection
WARNING
IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS SERVICE CENTER.
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped with a
Plug the appliance into an exclusive properly
This appliance requires a standard 115/120 Volts A.C. ~/ 60Hz electrical outlet with
The cord should be secured behind the appliance and not left exposed or dangling to prevent accidental injury.
Do not use an adapter plug with this appliance.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified electrician or service technician install an outlet near the appliance.
Steps To Replace Water Bottle
zUse a clean cloth to wipe off neck of bottle.
zRemove cap (if one is present).
zCarefully lift bottle, do not place hands on the opening of the bottle while placing on the water intake opening.
zInsert the water bottle into the water intake over the reservoir opening so that it settles properly.
zWipe off any water which may have splashed on dispenser top.
6