Height Adjustment Platform
To make the water dispenser faucets more accessible your unit has been supplied with a height adjustment platform. The platform requires assembly as shown below.
Parts Provided:
1 Front Panel
1 Back Panel
1 Stability Ring (located on the top foam cover)
2 Short Screws and 2 Long
a)Align both the front and back panels of the platform and assemble as shown in figure 1.
Front Panel
Back Panel
Fig. 1
b)Align the assembled platform to the bottom stability ring as shown in figure 2a. Align the areas marked “1” and “2” on the platform with same areas marked “1” and “2” on the stability ring.
(NOTE: These areas must be aligned correctly for the unit to be assembled. If the platform is not aligned correctly to the stability ring, the retaining clips could be permanently damaged and cause the platform to be
Bottom Ring
Fig 2a
7