CDA HCC310 manual Installation Instruction, Technical Information for the Installer

Installation Instruction

TECHNICAL INFORMATION FOR THE INSTALLER

Before installing the cooktop, remove the protective film.

This cooktop can be built into a working surface 30 to 40 mm thick and 600 mm deep.

In order to install the ceramic griddle into the kitchen fixture, a hole with the dimensions shown in fig. 3 has to be made, keeping in considera- tion the following:

✓within the fixture, between the bottom side of the ceramic griddle and the upper surface of any other appliance or internal shelf there must be a clearance of at least 30 mm;

✓the ceramic griddle must be kept no less than 300 mm away from any side wall;

✓the rear wall must be at least 50 mm from the ceramic griddle and must withstand a temperature of 150°C.

✓there must be a distance of at least 650 mm between the hob and any wall cupboard or extractor hood positioned immediately above (see fig. 4)

✓the coatings of the walls of the unit or appliances near the cooktop must be heat resistant (“X” protection against heating in compliance with standards EN 60335-2-6).

✓Do not instal the appliance near inflammable materials (eg. curtains).

Figure 3

288

50

490	+	0
	–
	2

Figure 4

450 mm 650 mm

300 mm

510

	0
	+ 2
270	–

8