Black & Decker # 900149 user manual Step C Sanitize Reservoirs, Step D Rinse Reservoirs

Model # 900149: Page 10

2.Wipe probe and area around all 3 taps with a soft cloth moistened with the sanitizing solution.

Step C: Sanitize Reservoirs

1.Remove the cap from a spare empty 5 gallon bottle.

2.Fill the bottle with sanitizing solution.

3.Insert probe into bottle and secure by tightening handle clockwise.

4.Slide bottle into cabinet and close door.

5.Plug power cord into a grounded wall outlet.

6.Turn energy saving switches ON.

7.Allow the water and bleach mixture to fill the empty reservoirs.

8.Wait 10 minutes then turn energy saving switches OFF and unplug the power cord.

9.Place a 2 gallon or larger bucket under the drain plug in the rear of the dispenser.

10.CAUTION: Remove drain cap and silicon plug. Cold water will immediately flow into the bucket. Several seconds’ later hot water will dispense.

Reminder - Place drain cap and silicon plug in a safe location so they are not lost.

11.Once unit has drained, replace silicon plug and drain cap.

12.Remove remaining water from reservoir by dispensing from the cold and cool taps into a pitcher.

Step D: Rinse Reservoirs

1.Dispose of sanitizing solution and rinse bottle with tap water.

2.Fill the bottle with tap water and insert probe into bottle.

3.Push down on probe until it is seated.

4.Create a seal by turning handle clockwise until tight – do NOT over tighten.

5.Slide bottle into cabinet and close door.

6.Plug power cord into a grounded wall outlet.

7.Allow the water and bleach mixture to fill the empty reservoirs.

8.Wait 10 minutes then turn energy saving switches OFF and unplug the power cord.

9.Place a 2 gallon or larger bucket under the drain plug in the rear of the dispenser.

10.CAUTION: Remove drain cap and silicon plug. Cold water will immediately flow into the bucket. Several seconds’ later hot water will dispense.

Reminder - Place drain cap and silicon plug in a safe location so they are not lost.

11.Once unit has drained, replace silicon plug and drain cap.

12.Remove remaining water from reservoir by dispensing from the cold and cool taps into a pitcher.

13.Return the unit to its location, install a fresh water bottle, plug the power cord back into the grounded wall outlet and turn the energy saving switches ON.