Ariston LI 68 DUO Multisystem racks, What goes into the lower rack?, How to adjust the top rack

D ISHWASHER

How to load your dishes

Before washing, a few small steps can help you get a better wash and keep your dishwasher for longer. Remove the largest scraps of food left over on your plates, soak saucepans and frying pans with tough incrustations. After loading your dishes, make sure the blades on the sprayer arm turn well

First of all.

Before placing the dishes in the racks, remove the largest scraps of food left over on your plates, you will thus avoid blocking the filter, which would reduce the efficacy of the wash.

If the saucepans and frying pans are very dirty, allow them to soak before being washed. To make it easier to load your dishes, pull the racksout.

Multisystem racks

Thisdishwashermodelisfittedwith newerandmoremodernupperand lower racks and a cutlery basket. They are made to provide greater flexibilityinloadingdishes,making them more suitable to meet your specific needs.

The rack handles can be cleaned regularly:pulloutthetwofastening plugs,removethehandlesandrinse themunderrunningwater.Putthe handles back in place and fasten them using the plugs you removed previously.

What goes into the lower rack?

Werecommendyouplacethemost difficult dishes to wash into the lower rack: saucepans, lids, soup dishes and plates, but also: mugs, cups and glasses (see photos for load examples).

•Serving dishes and large lids: place them on the sides oftherack.

•Saucepans, salad bowls: mustalwaysbeplacedupside down

•Very deep dishes: place them obliquely, thus allowing water to run down them and cleaningthembetter

•Glasses and cups: Position

themasindicatedinthefigure.

The cutlery basket can be split up by pulling out the handle and removingthemetalclipthatkeeps the two parts joined together.

When you only have little cutlery to wash, you can use just half the basket; save space for other crockery or place the other half of thebasketintheupperrackinstead (see figures A and B).

This basket is equipped with two removable grids: insert the cutlery one by one into the slots, with the handles at the bottom. Position them so that they don't touch.

In this specific model, the cutlery

basket is fitted with two detachablesidecompartments,as shown in figure A1, which can be hooked on either to the upper or lower rack, as required.

What goes into the upper rack?

Place delicate and lightweight dishes in the upper rack: glasses, tea cups and coffee cups, saucers

-but plates too - shallow salad bowls,slightlydirtyfryingpansand shallowpans.

Positionlightweightdishes insuch awayastoavoid theirbeingmoved by the spray of water.

Theappliancecanalsobeequipped with one or two tip-up compartmentsontowhichyoucan place mugs and cups, as well as long sharp knives and serving cutlery.

Afterloadingthedishes,remember to check that the blades on the sprayer arms can turn freely without hitting against any dishes.

How to adjust the top rack.

The upper rack can be set in high or low position to enable you to organise your dishes effortlessly.

F i g . C

There are two handles on the sides of the upper rack: use these to adjust its height (see fig. C)

A1

A

B

	Load examples
lower rack	upper rack

Where to put the different parts of the cutlery basket

ARISTON DISHWASHER - Instructions for installation and use 3