Extron electronic MPA 401 manual Troubleshooting, Amplifier Fails to Exit Standby Mode Promptly

Page 19
Troubleshooting

Troubleshooting

Under different circumstances, the front panel LED lights green or amber, which provides diagnostic information.

Amplifier Fails to Exit Standby Mode Promptly

Power LED

Problem Description

Problem Solution

Color

 

 

 

 

 

Amber

No output signal.

No input detected: verify that there is an

 

 

input signal.

 

 

If a signal is present, raise the input level.

 

 

The amplifier is in standby mode and the

 

 

output has been turned off. Check the

 

 

remote port.

 

 

 

Green or

Slow to exit standby

The input signal may be too weak. Raise

Amber

mode when a signal is

the input level.

 

present.

 

Amplifier Enters Standby Mode Too Early

Power LED

Problem Description

Problem Solution

Color

 

 

 

 

 

Green or

Enters standby mode

The input signal may be too weak. Raise

Amber

early.

the input level.

MPA 401-70V and MPA 401-100V • Setup and Operation

13

Image 19
Contents Audio MPA 401 SeriesMini Power Amplifiers User GuideInstructions de sécurité Français Safety InstructionsSafety Instructions English Chinese Simplified(简体中文)FCC Class B Notice Conventions Used in this Guide Specifications AvailabilityNotifications Rear Panel and Cabling ContentsSetup and Operation IntroductionMPA 401-70Vand MPA 401-100V Contents Introduction Important Safety InstructionsImportant Safety Instructions MPA 401-70Vand MPA 401-100VFeaturesFigure 1. Typical Application for the MPA MPA 401-70Vand MPA 401-100VDescriptionMPA 401-70Vand MPA 401-100V Introduction MPA 401-70Vand MPA 401-100VFeaturesRear Panel Rear Panel Power Input Audio InputsRemote Input Connector Speaker Connections Rear Panel and CablingPower Input Audio Inputs Remote Input Port Wiring for remote controlPage Speaker Connections Setting Bass and Treble Remote Control Options Setup and OperationFront Panel Features Front Panel Features Setting Input LevelSetting Bass and Treble Setting Input LevelExtron SI 3CT LP Remote Control OptionsMPA 401-70Vand MPA 401-100V Setup and Operation Extron MPAAmplifier Fails to Exit Standby Mode Promptly TroubleshootingAmplifier Enters Standby Mode Too Early Mounting Plenum PlacementTabletop Placement Reference MaterialUnder-desk, Through-desk,and Projector Mounting Rack Mounting ProcedureExtron Warranty