Haier HR-2080EG, HR-2485EG manual FIG. a

English Instruction for use

FIG. A	COMPONENTS
10	1
11	2
	3
	4
	5
12	/Kg
	+30S
	6
13	7
	8
	9
	14

Legend of Components

Availability of components depending on Mod. / Type of appliance

1	-	Cabinet	10	-	Oven interior
2	-	Interior light	11	-	Door hinge
3	-	Control panel	12	-	Door
4	-	LED display	13	-	Door seal
5	-	Operate button	14 -		Gridiron

6- Circular track(for turntable undercarriage)

7- Turntable drive

8- Turntable undercarriage

9- Turntable

English Instruction for use

f)Place the undercarriage in the circular track on the oven interior floor

g)Lay the turntable onto the undercarriage. By gently turning it, the guide fits into the drive shaft.

Place the appliance on an even and non-skid surface.

It must be stable enough to easily support the appliance even if the oven contains goods.

Leave a space of at least 15 cm between the foremost edge of the worktop and the front of the oven door .

You will thus prevent the appliance from tilting forward when the door is open.

Install the oven in a place where it is protected against splashing water or dripping liquids.

Never operate the appliance outdoors. Sunlight and humidity may impair operational safety.

Never expose your microwave oven to direct sunlight (overheating hazard).

Do not install the appliance in the immediate vicinity of heat sources such as radiators or cookers.

The following minimum clearances between other objects / walls must be maintained for safety

purposes:
- Side l/r clearance	at least 5 cm
- Rear clearance	at least 30 cm
- Upper clearance	at least 30 cm

The appliance must not be built into a cupboard.

The oven must not be built in underneath a panel or a cupboard.

For some models a built under - mounting set is commercially available. Please ask your dealer or the respective customer support service.

CAUTION!

During operation clouds of steam escape through the air vents of the appliance and it may get very hot within the space of the above mentioned minimum clearances. The microwave oven should thus be installed so that no objects sensitive to heat or moisture are located near the minimum clearances.

Avoid any possible overheating of the oven caused by unintentionally covering or sealing the air vents When in operation the base of the oven may become very hot. The worktop must thus be accordingly heat-resistant.

4 Rating Plate

The rating plate with technical specifications is located on the cabinet, at the rear of the oven.

5 Plugging in your appliance

Your appliance must be connected to a power socket with grounded connection, which complies with the respective regulations and has been installed by an authorised specialists.

Before plugging the appliance into the wall socket, make sure that the voltage(V) and fuse amperage

(A)specified on the rating plate of the oven correspond with the electrical power supply in your home. If these specifications do partly or not at all correspond, immediately contact your local customer support service or your dealer and do no plug in the appliance under any circumstances.

11 4