Detergent and Rinse Aid, Loading the detergent

Detergent and Rinse Aid

Detergent

Detergent specifically intended for use with dishwashers must be used.The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table". The detergent dispenser is located on the inside panel the door.

Loading the detergent

To open the "A" cover on the dispenser,press the "B" button.The detergent for the wash cycle should be poured into the "C" compartment.

After the detergent has been placed in the dispenser, close the cover and press down until it clicks in place.

CPre-wash

Extended wash

Notice:To facilitate closing the cover, remove any excess

detergent on the edges of the dispenser.

Rinse Aid

This product makes dishes sparkle and helps them to dry with- out spotting.The dispenser is located on the inside panel of the door and should be filled after every 80 wash cycle (or when the rinse aid indicator light comes on for those models with this feature).

Loading the Rinse Aid

To open the dispenser,turn the "C" cap in the anti-clockwise dierction and then pour in the rinse aid,making sure not to overfill. The amount of rinse aid used for each cycle can be regulated by turning the "F" dose adjustor ,located beneath the "C" cap, with a screwdriver.There are 6 different settings; the normal dosage setting is 3.

Important

Proper dosage of the rinse aid improves drying.

If drops of water remain on the dishes or spotting occurs,the dosage adjustor should be turned to a higher setting.

If the dishes have white streaks,turn the dosage adjustor to a lower setting.

.4.