Henny Penny OE 301 installation instructions 11.25

The OE-301/302/303 is available from the factory wired 208, or 220/240 volts, 50 or 60 hertz source. Refer to the table below for supply wiring and fusing.

Volts	Phase	KW	Amps
208	3	11.25	31
208	3	13.50	38
220/240	3	11.25	30132
2201240	3	13.50	33135
400	3	11.25	16
400	3	13.50	20

This fry station must be adequately and safely grounded. Refer to local electrical codes for correct grounding procedures. If fry station is not adequately grounded, electrical shock could result.

A separate disconnect switch with proper capacity fuses or breakers must be installed at a convenient location between the fry station and the power source.

I

Each Hentry Penny Fry Station was completely checked and tested prior to shipment. However, it is good practice to check the unit a again after installation.