Extron electronic user manual VersaTools MDA 3 Series, cont’d, Back of the rack mounting

VersaTools® MDA 3 Series, cont’d

Back of the rack mounting

The MDA can be mounted to the rear of a rack using the Extron MBB 100 VersaTools® back of the rack mounting kit

(part #70-367-01) (figure 3). The kit allows the product to be vertically mounted to the front or rear rack supports and facing either towards the front or the rear of the rack.

Rear

1

2

3

	I
4	NP
	UTS

5

6

7

8

1

2

3

O	UTP
4
	UTS

5

6

7

8

ENTER

PRESET

Figure 3 — Attaching the back of the rack kit

AV

VID

AUD

MA
M	V S
I/ATRIX		ERI
O		SW	ES
+dB		ITCHER
-
dB
AUDIO
	SETUP

Front

DISTRIBUTION AMPLIFIER

1. Remove feet from the bottom of the MDA if they are installed.

2.	Remove two screws from one side of the unit. Retain the	Figure 4 — Typical back of the rack installations
	screws for possible later reassembly without the bracket.
3.	Attach one bracket to the side of the unit using the longer
	screws included in the kit.
4.	Repeat steps 2 and 3 on the other side of the unit.
5.	Mount the unit to the rack using the two included rack
	screws (figure 4). The MDA can be vertically mounted
	facing in either direction.

Only VersaTools products and most IP Link products can be mounted using the back of the rack mounting kit.

4	VersaTools	®	MDA 3 Series • Installation	VersaTools	®	®	5
						MDAVersaTools3 Series •MDAConnections3 Series •andInstallationControls