GE Monogram ZBD5700, ZBD5900, ZBD5600 manual Start a wash load Tone Silencing, NSF International

Start a wash load

Tone Silencing

Control Panel — ZBD5700 & ZBD5900

Dishwasher

4.WATER TEMP—This option provides extra heat to increase water temperature for best performance.

It is used best with heavily-soiled dishes. This option cannot be used with RINSE & HOLD.

NORMAL—This is the default setting—wash and rinse water temperatures up to 149°F.

BOOST—This water temp selection provides a wash and rinse with water temperatures up to 158°F.

SANI—This water temp selection provides a sanitizing wash and rinse with water temperatures up to 171°F.

		S	ID	E	N T	I	NSF INTERNATIONAL
	E
R						A	Meets NSF Protocol for Performance of Domestic Spray-
						L
							Type Dishwashers [No. 96/011/480/2480] Requirements
							for cleaning and sanitization of dishes, glasses and utensils.

5.DELAY START—This option will allow you to delay the start time of any wash cycle except RINSE & HOLD for up to 6 hours.

1.Select the delay start you want by pressing the DELAY START button. Multiple pressing will alternate the delay time between 2, 4 or 6 hours and OFF.

2.Select the wash cycle you want. The DELAY START light/lights will flash to indicate time selected.

3.The flashing Cycle Status Indicators show how many hours will elapse before washing begins.

6.CLEAR—If you wish to change the wash cycle after it has started or wish to turn the dishwasher off before the wash finishes, it’s simple. First pause the dishwasher by pressing the selected Cycle Selection button, then press the CLEAR button. The dishwasher will then drain. You can now select a new wash cycle if you want. If you don’t, the dishwasher will drain and all Cycle Status Indicators will go out. If you have selected a new wash cycle, remember to add more detergent to the detergent compartment if required.

To start the dishwasher, close the door until it locks in place, push the desired Cycle Selection button, and then select the desired Option buttons. There is a time delay between start-up and water fill so you will not hear any wash action right away.

The door must be closed and latched into place to select a CYCLE Selection or an option.

If the door is opened during a cycle and left open, the dishwasher will beep once every minute until the door is closed and latched into place.

To interrupt/pause a cycle, press the selected cycle button. The Status Indicators will flash.

CAUTION: Be careful when opening the door; the hot steam that escapes when the door is opened may cause injuries. Stand back as you open the door and allow the steam to escape.

ATTENTION : Faites attention lorsque vous ouvrez la porte. La vapeur brûlante qui s’échappe lorsque vous ouvrez la porte pendant un programme de lavage peut causer des brûlures. Lorsque vous ouvrez la porte, reculez et laissez la vapeur s’échapper de l’appareil.

To restart the wash process, close the door until it locks in place. Re-press the cycle button. There may be a time delay of up to a few minutes because the water temperature needs to stabilize before it starts the wash cycle. During this time the DRY light will be on.

You can prevent the beep from sounding when selecting control settings.

1.Press the CLEAR and FAST WASH buttons together prior to selecting settings.

2.To have sound again, simply press the CLEAR and FAST WASH buttons together again.

10