GE Monogram ZBD3500 manual Display Tells YOU if Certain Things are Wrong, Failure Occurred

THE DISPLAY TELLS YOU IF CERTAIN

THINGS ARE WRONG

DISPLAY		WHAT IT MEANS	WHAT TO DO
		Electrical power to the dishwasher	IF DISHWASHER WAS IN USE WHEN THE POWER
		has been interrupted but is now	FAILURE OCCURRED:
	RESET	back on.	1.	Press the RESET pad and wait approximately 30 seconds.
			2.	Unlatch and open the door.
				A) If the detergent cup is open and empty and the
					dishwasher was set for the NORMAL, POTS PANS
					or CHINA CRYSTAL cycle, close door and put the
					load through a RINSE HOLD cycle. After the RINSE
					HOLD cycle is completed, add detergent and reset the
					load for the washing cycle you want.
				B) If the detergent cup is closed and the dishwasher was set
					for the NORMAL, POTS PANS or CHINA CRYSTAL
					cycle, reset the dishwasher for the wash cycle you want.
				C) If the dishwasher was set for the RINSE HOLD cycle,
					reset the dishwasher for RINSE HOLD.
			IF THE DISHWASHER WAS NOT IN USE when power
			failure occurred, use dishwasher as you normally would.
		Slow draining. The dishwasher is	This dishwasher is designed to automatically compensate
		taking longer than normal to drain	for longer than normal drain times, but cycle time will be
		the water out. This is usually caused	extended. If this code continues to appear frequently:
		by a blockage in the drain air gap	1.	Clean the air gap (See Air Gap section).
		(see Air Gap section), a kink in the
			2.	Check for a kink in the drain hose.
		drain hose, or a stopped-up pipe.
			3.	Check plumbing for slow or stopped-up drains. (NOTE:
				Warranty service does not cover household drain problems.)
		Drain is blocked. Similar to slow	Press the RESET pad to stop the beep.
		drain. This indicates that the drain	Locate and remove the blockage in the drain system.
	RESET	is so clogged that the dishwasher	To pump any remaining water out of the machine:
		cannot continue to operate in a
			1.	Latch door.
		satisfactory manner. Dishwasher
		will stop.	2.	Select any cycle.
			3.	Touch “START” and then immediately touch RESET.
				(NOTE: Warranty service does not cover household
				drain problems.)
		Drain sensor is not functioning.	If		repeats for the next cycle, call for service.
		Dishwasher will continue cycle
		along with a fixed drain period.
		There is too much water in	Press the RESET pad to stop the beep.
		the dishwasher.	The dishwasher is designed to automatically pump out
	RESET		extra water as long as the door is latched. When you hear
			the motor stop running:
			1.	Unlatch the door and see if all the water is gone.
			2.	If you see water entering the dishwasher, close and latch
				the door. Shut off the water supply to the dishwasher.
			3.	If water is gone and no water is entering the dishwasher,
				restart cycle.
			4.	If	repeats, shut off the water supply to the
				dishwasher. Call for service.

10