GE Monogram JGP645 operating instructions Important Safety Instructions Dimensions and Clearances

Page 14

INSTALLATION INSTRUCTIONS

(continued)

IMPORTANT SAFETY INSTRUCTIONS

DIMENSIONS AND CLEARANCES

The cooktop has been design certified by the American Gas Association. As with any appliance using gas and generating heat, there are certain safety precautions you should follow. You’ll find these precautions in this Use and Care Guide; read it carefully.

• Be sure your cooktop is installed properly

by a qualified installer or service technician.

• The cooktop must be electrically grounded in

accordance with local codes, or in their absence,

with the National Electrical Code ANSI/NFPA

No. 70–Latest Edition.

• Installation of this cooktop must conform with

local codes, or in the absence of local codes, with

the National Fuel Gas Code. ANSI Z223.1–Latest

Edition.

• Disconnect electrical supply before servicing.

• Make sure the wall coverings around the

cooktop can withstand heat generated by the

cooktop up to 200°F.

• Avoid placing cabinets above the cooktop.

• If cabinets are placed above the cooktop, allow

a minimum clearance of 30″ between the cooking

2″

36″ 221⁄4″

83⁄4″

15″

13″ Max.

30″ Min. 18″

Min.

8″ Min. to wall when installed

2″

8″ Min. to wall when installed

surface and the bottom of unprotected cabinets.

• If cabinets are placed above the cooktop, use

cabinets no more than 13″ deep.

• If a 30″ clearance between cooking surface and

overhead combustible material or metal cabinets

cannot be maintained, protect the underside of

the cabinets above the cooktop with not less than

1/4″ insulating millboard or gypsum board at

least 3/16″ thick covered with 28 gauge sheet

steel or 0.020″ thick copper.

• Clearance between the cooking surface and

protected cabinets MUST NEVER BE LESS

THAN 24″. The vertical distance from the plane

of the cooking surface to the bottom of adjacent

overhead cabinets extending closer than 1″ to

the plane of the cooktop sides must not be less

than 18″.

14

The downdraft system with blower, motor and ductwork will occupy the cabinet below the cooktop. Drawers cannot be installed below this cooktop.

Avoid placing cabinets above the cooktop unit,

if possible, in order to reduce the hazards caused by reaching over heated surface units.

If the cabinetry is used above the cooktop, allow a minimum 30″ clearance between the cooking surface and the bottom of the unprotected cabinet.

If the clearance between the cooktop and the cabinetry is less than 30″, the cabinet bottom must be protected with a flame retardant millboard at least 1/4″ thick, or gypsum board at least 3/16″ thick, covered with 28 gauge sheet steel or 0.020″ thick copper. Clearance between the cooktop and the protected cabinetry MUST NEVER BE LESS THAN 24″.

EXCEPTION: Installation of a listed microwave oven or cooking appliance over the cooktop shall conform to the installation instructions packed with that appliance.

Working areas adjacent to the cooktop should have an 18″ minimum clearance between the countertop and the bottom of the cabinet.

If the clearance is less than 18″, the adjacent cabinets should be at least 8″ from the side of the cooktop.

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Before You Safety Instructions Operating Instructions, TipsInstallation Instructions If YOU Need Service Help US Help YOU…Important Safety Instructions When You Get Your CooktopUsing Your Cooktop Turn the controls off. Smother aSave These Instructions Keep all plastics away from burnersFeatures of Your Cooktop ExplainedHOW does this Cooktop Compare To Your OLD ONE? Type of Cooktop Description How It Works Gas BurnersElectric Ignition Using Your CooktopHow to Select Flame Size To Light a BurnerStove Top Grills CookwareWok Cooking Do not use woks thatRaising or Lowering the Vent How to Operate the Vent SystemCooktop Vent System Vent fan will only operate in the fully extended positionGlass Cooktop Care and CleaningPower to the Cooktop at the fuse box or Grease FiltersBurner Assembly Burner GratesParts List Installation InstructionsFor Your Safety Before YOU BeginImportant Safety Instructions Dimensions and Clearances Notches at the back of the cutout are Preparing the Countertop CUT the OpeningCountertop cutout for the cooktop must be Follow the illustration shownPrepare ductwork to vent to outdoors Plan the DuctworkDuctwork Arrangement To accurately locate the ductwork holes in the cabinet floor Do not use flexible plastic ducting Duct FittingsFlexible ducting Electrical Supply Power Supply LocationsGas Supply Important Please read carefullyInstall the Motor/Blower Assembly Install Downdraft VentInstall Adjustable Support Brackets Install the DuctworkInstall the Pressure Regulator Install the CooktopConnect Power Electrical ConnectionsCheck for proper ignition Install Filters, Check Operation of DowndraftAssemble Burners, Check Ignition Converting to LP GAS Or Converting Back to Natural Gas from LPConvert the Pressure Regulator Yellow flamesQUESTIONS? Before YOU Call for SERVICE… Problem Possible CauseWe’ll Be There Warranty

JGP645 specifications

The GE Monogram JGP645 is a high-performance gas cooktop designed to elevate your culinary experience with its professional-grade features and advanced technologies. This model embodies quality craftsmanship and innovation, making it a favorite among both home cooks and professional chefs.

One of the standout features of the GE Monogram JGP645 is its powerful burners. It boasts five sealed burners, including a dual-flame stacked burner that can provide up to 20,000 BTUs of heat. This allows for precise temperature control, facilitating everything from simmering sauces to searing meats. The cooktop is designed to accommodate a variety of cookware sizes, making it versatile for different cooking styles.

The surface of the JGP645 is constructed from durable stainless steel, ensuring not only an elegant appearance but also resistance to stains and easy maintenance. The heavy cast iron grates are robust and provide excellent stability for pots and pans, offering a professional look and feel. They are designed to be easily removable, making cleaning quick and effortless.

Incorporating advanced cooking technologies, the GE Monogram JGP645 includes an automatic re-ignition feature. Should a flame extinguish, this innovation ensures that the burner will reignite itself automatically, providing peace of mind during the cooking process. This cooktop also comes equipped with a precise simmer option on select burners, allowing you to maintain low temperatures for delicate dishes, like sauces and custards.

User convenience is enhanced with the cooktop’s ergonomic knob controls, which are easy to operate, even with wet or greasy hands. The continuous grates allow for smooth transitions between pots and pans, eliminating the need to lift them when changing cooking elements.

Safety is a top priority with this gas cooktop. It features a flame failure system that prevents gas from flowing if the flame is extinguished, ensuring a secure cooking environment. The JGP645 also comes with a stylish, integrated design that seamlessly fits in with a variety of kitchen aesthetics.

In conclusion, the GE Monogram JGP645 gas cooktop combines professional performance with user-friendly features, making it an ideal choice for anyone looking to enhance their cooking capabilities. Its robust design, advanced technology, and high efficiency make it a standout option in the realm of luxury kitchen appliances.
Top Page Image Contents