Stainless steel surfaces, Painted Surfaces

Care and Cleaning

Chimney Vent Hood

Stainless steel surfaces

(on some models)

Do not use a steel wool pad; it will scratch the surface.

To clean the stainless steel surface, use warm sudsy water, a stainless steel cleaner such as Kleen King® or an all-purpose liquid or spray cleaner. Always scrub in the direction of the grain. Rinse thoroughly with a sponge or cloth and clean water. Dry with a soft, clean cloth.

After cleaning, use a stainless steel polish, such as Stainless Steel Magic®, Revere Copper and Stainless Steel Cleaner® or Wenol All Purpose Metal Polish®. Follow the product instructions for cleaning the stainless steel surface.

Painted

Surfaces

(on some models)

Glass visor

Clean any painted surfaces with a mixture	Do not use commercial oven cleaners, cleaning
of water and either soap or vinegar.	powders, steel wool or harsh abrasives on any
	painted surface.

Pull the glass visor out and wash it with a damp soapy cloth. Dry it with a clean cloth and push it back into place.

Light bulbs

NOTE: The glass cover should be removed only when cold. Wearing latex gloves may offer a better grip.

CAUTION: Before replacing the bulb, disconnect electrical power to the hood at the main fuse or circuit breaker panel.

ATTENTION : Avant de remettre en place l’ampoule, débranchez le courant de la hotte en enlevant le fusible principal ou en faisant basculer le disjoncteur au panneau d’alimentation.

Receptacle

Socket

Bulb

Be sure to let the light cover and bulb cool completely.

For your safety, do not touch a hot bulb with bare hands or a damp cloth.

To remove:

1Insert your finger nail into the inner glass cover slot and pull down. Remove cover.

NOTE: Do not remove outer retaining ring.

2Using gloves or a dry cloth, remove the bulb by pulling it straight out.

To replace:

1Use a new 12-volt, 20-watt Halogen bulb for a G-4 base.

2Using gloves or a dry cloth, remove the new bulb from its packaging.

NOTE: Do not touch the new halogen bulb with bare fingers. Touching the bulb with bare fingers will significantly reduce the life of the bulb.

3Push the bulb straight into the receptacle all the way.

Glass cover

ONLY use a new 12-volt, 20-watt Halogen bulb for a G-4 base.

Receptacle

Use gloves or cloth

For improved lighting, clean the glass cover frequently using a damp cloth. This should be done when the hood is completely cool.

4Snap the glass cover into the retaining ring.

5Reconnect electrical power to the hood.