Miele BSD9XP, BFD9XP manual Regenerating salt indicator, Rinsing liquid indicator light

EN 6/ LOADING OF REGENERATING SALT

EN 7/ LOADING OF RINSING PRODUCT

• Loading of regenerating salt (Fig 06)

Filling with salt is essential for providing a
good wash without marks. It regenerates the
resins that soften the water, by removing its
lime content (unless the mains water supply is
soft enough). Refer to “Setting the water sof-
tener”.
Important :
Only use special dishwasher regener-
ating salt. Do not use table salt or any type of
cooking salt, this could damage your appli-
ance’s water softener.
A Unscrew and remove the stopper on the
salt tank.
B Fill the tank with regenerating salt special-
ly designed for dishwashers.
C Use the funnel supplied with your dish-
washer. The first time, top up with water up to
the rim of the tank.
• Regenerating salt indicator:
This illuminates when salt must be added.	Fig. 06
After the tank has been filled with regenerat-
ing salt, the indicator light may remain lit until
the salt has dissolved sufficiently, usually
after one cycle (of if the tank has not been
filled completely; for example, when first put-
ting the machine into service using the sam-
ple).
This can be deactivated as indicated in the
paragraph “For multi-purpose products” set-
ting table.
Important

If the salt overflows when filling the tank, to avoid oxidization of the tub it is advisable to remove the salt crystals or to run a Prewash programme (or Rapid programme - depending on the model).

A

S a lt

B

r te a w

C

• Loading of rinsing product (Fig. 07)

Important :

Only use a rinsing product designed for dishwashers. The rinsing product ensures your items shine and are well dried.

AB When first putting the machine into service, fill the tank until the level is flush with the top of the adjustment lever. Pour in at least all the rinsing product provided.

The tank contains 120 ml (approximately one glass)

The original setting is in the centre (middle position: reference mark 2). If you encounter marks or poor drying after a few cycles, you can adjust the setting using the adjustment lever (fig 07 C ; Reference mark 3 will increase the setting).

-Close the tank lightly

•Rinsing liquid indicator light:

This illuminates when rinsing product is required.

It can be deactivated as shown in the para- graph “For multi-purpose products” setting table.

Important :

If any of the product overflows during filling, sponge up the excess to avoid pro- ducing foam.

A

1 23

B

1 23

C

Fig. 07 Adjustment lever

12 13