Ice/Water Dispenser
Using the Ice/Water Dispenser for the first time
Before using the Ice/Water Dispenser for the first time, you must flush then fill appliance water lines with water.
Flushing the lines of the Ice/Water Dispenser
Open the freezer door.
Touch the "Access" button so it turns yellow.
Touch the "ice" sensor button so it turns yellow.
Close the appliance door.
After opening and closing the door, it may take a few seconds before the Ice/Water Dispenser is ready for use.
The "water" button on the control panel of the Ice/Water Dispenser flashes white.
Place a large container under the dispenser.
Touch the "water" button until it flashes yellow.
Touch and hold the "water" button again.
This activates the flushing function, which uses approximately 1.6 gallons (6 liters) of water.
You can interrupt the flushing process at any time to empty the container, by taking your finger off the "water" button. During this time, the "water" button will flash yellow again.
As soon as the flushing process is complete, you will hear a beep, and the buttons on the control panel will turn white.
You can now use the Ice/Water Dispenser.
For the automatic ice/water dispenser to operate, it must be connected to the household power and water supply.
Use sturdy glass when dispensing water or ice - risk of injury from broken glass!
Keep fingers clear of the dispenser opening. Risk of injury!
21