Miele K 9212 I, K 9412 I installation instructions Technical safety

Page 9

Warning and Safety instructions

Technical safety

Before setting up the appliance, check it for any externally visible

damage.

Do not install and use a damaged appliance.

This appliance contains the coolant Isobutane (R600a), a natural gas

which is environmentally friendly. Although it is flammable, it does not damage the ozone layer and does not increase the greenhouse effect. The use of this environmentally friendly coolant has, however, led to a slight increase in the noise level of the appliance. In addition to the noise of the compressor, you might be able to hear the coolant flowing around the system. This is unavoidable, but does not have any adverse effect on the performance of the appliance.

Care must be taken during the transportation and installation of the appliance that no parts of the coolant system are damaged. Leaking coolant can damage the eyes.

In the event of any damage:

-avoid open fires and anything which creates a spark,

-disconnect from the mains,

-air the room in which the appliance is located for several minutes and

-contact the Service Department for advice.

The more coolant there is in an appliance, the larger the room it should be installed in. In the event of a leakage, if the appliance is in a small

room, there is the danger of combustible gases building up.

For every 8 g of coolant at least 1 m3 of room space is required. The amount of coolant in the appliance is stated on the data plate inside the appliance.

Before connecting the appliance to the mains supply, make sure that

the rating on the data plate corresponds to the voltage and frequency of the household supply. This data must correspond in order to avoid the risk of damage to the appliance. Consult a qualified electrician if in any doubt.

The electrical safety of this appliance can only be guaranteed

when continuity is complete between it and an effective earthing system which complies with current local and national safety regulations. It is most important that this basic safety requirement is present and tested regularly, and where there is any doubt, the household wiring system should be inspected by a qualified electrician. The manufacturer cannot be held liable for damage or injury caused by the lack of or inadequacy of an effective earthing system (e.g. electric shock).

If the connection cable is faulty it must only be replaced by a Miele approved service technician to protect

the user from danger.

9

Image 9
Contents Page Contents Contents Guide to the appliance Guide to the appliance Bottle rack Optional accessoriesCaring for the environment Disposal of the packing materialDisposal of your old appliance Correct application Safety with childrenTechnical safety Correct use Page Disposal of your old appliance Normal energy Increased energy Consumption How to save energyDefrosting How to save energyBefore using for the first time Switching on and offSwitching on Switching offSetting the temperature Correct temperatureFor the refrigerator section For the freezer compartmentTemperature display Switching off Super cool Switching on Super coolSuper cool Super coolDifferent storage zones Using the refrigerator efficientlyFood which should not be stored in a refrigerator Warmest areaWhen shopping for food Storing food correctlyFruit and vegetables Unpacked meats and vegetables Protein rich foodsMeat Adjusting the door shelf/bottle shelf Adjusting the interior fittingsMoving the shelves Split shelfMoving the bottle divider Freezing and storing food depending on model Using the freezer compartmentFreezing fresh food Storing frozen foodHints on home freezing Home freezingPacking Unsuitable packing material Suitable packing materialDefrosting Before placing food in the freezer compartmentPlacing food in the freezer section Cooling drinks Ice cubesRefrigerator section DefrostingFreezer compartment Before defrostingAfter defrosting To defrostBefore cleaning Cleaning and careCleaning the interior and accessories ClothAfter cleaning Ventilation gapsDoor seal Temperature in the refrigerator is too low Problem solving guideAppliance is switching in too frequently and for too long What to do if Appliance does not get coolFood has frozen together There is a thick layer of ice in the freezer compartmentInterior light in the refrigerator is not working Floor of the refrigerator section is wet Normal noises What causes them NoisesAfter sales service Non-rewireable plugs BS Electrical connectionElectrical connection U.K Location InstallationVentilation Climate rangeBefore installation 9212 9412 Building-in dimensionsChanging the door hinging Appliance doorOpen the appliance door Freezer compartment door Building in the appliance Aligning the housing unitBuilding into a peninsular run Preparing the applianceBuilding in the appliance Securing the appliance and fitting the furniture door Page Page Alteration rights reserved

K 9212 I, K 9412 I specifications

The Miele K 9412 I and K 9212 I represent the pinnacle of modern refrigeration, designed to meet the demands of both residential and commercial kitchens. These built-in refrigerators exemplify Miele's commitment to quality, innovation, and sustainability while ensuring that food storage remains as efficient and user-friendly as possible.

One of the standout features of both models is the Dynamic Cooling technology. This ensures a consistent and even temperature across the entire fridge, which is crucial for maintaining the freshness of perishable items. Dynamic Cooling eliminates the risk of hotspots and helps to preserve the nutritional value of the food, making it an ideal choice for health-conscious consumers.

Another remarkable characteristic of these refrigerators is their exceptional energy efficiency. The K 9412 I and K 9212 I are equipped with advanced energy-saving features that not only minimize electricity consumption but also contribute to reducing the overall environmental footprint. With energy ratings typically exceeding A+++, users can enjoy the peace of mind that comes with knowing they're making an eco-friendly choice.

Additionally, both models offer an interior that maximizes usage and flexibility. The adjustable shelving allows for customized storage solutions, accommodating everything from tall bottles to delicate produce. The premium interior design includes high-quality materials and finishes, which not only look sleek but also enhance durability.

Miele has integrated various conveniences into these units, including the ComfortClean door shelves. These can be easily removed and are dishwasher-safe, making cleaning and maintenance hassle-free. The refrigerator also incorporates efficient LED lighting that provides excellent visibility while consuming minimal energy.

Moreover, the Active AirClean filter eliminates unwanted odors, keeping the refrigerator smelling fresh and ensuring that food maintains its natural taste. In terms of design, the K 9412 I and K 9212 I are built for seamless integration into kitchen cabinetry, allowing for a clean and modern aesthetic.

Both models showcase Miele's dedication to superior product engineering, offering users a reliable, stylish, and technologically advanced refrigeration solution. With their combination of innovative features, energy efficiency, and elegant design, the K 9412 I and K 9212 I set a new standard for built-in refrigerators, appealing to those who appreciate the finer aspects of culinary storage and preservation.