Sears 51278, 51271 manual Inside, Sorage Drawers, Oulside

Page 12

Care and Cleaning

Oulside

The water and ice dispenser spill shelf should be wiped dry immediately to prevent spotting° Water left on the shelf may leave deposits that you can remove by soaking in undiluted vinegar° You can also

use a paste of non-precipitatingwater softener (such as Calgon brand) and water, or one teaspoon of citric acid powder per pint of hot tap water_ Soak until the deposit disappears or becomes loose enough to rinse away. Usually 30 minutes soaking time is adequate° Avoid using wax on the spill shelf and trim.

The door handles and trim can be cleaned with a cloth dampened with a solution of mild liquid

dishwashing detergent and water. Dry with a soft cloth_ Don't use wax on the door hand;es and trim_

Keep the finish clean. Wipe with a clean cloth lightly dampened with kitchen appliance wax or mild liquid dishwashing detergent. Dry and polish with a clean, soft cloth. Do not wipe the refrigerator with a soiled dishwashlng cloth or wet towel These may leave a residue that can harm the paint° Do not use scouring pads, powdered cleaners, bleach or cleaners containing bleach because these products can scratch and weaken the paint finish.

Protect the palnt finish. The finish on the outside of the refrigerator is a high quality, baked_on paint finish. With proper care, it will stay new-looking and rust-free for years. Apply a coat of kitchen/appliance wax when the refrigerator is new and then at least twice a year,

Inside

The fresh food and freezer compartment interiors should be cleaned at least once a year° Unplug the refrigerator before deaning_ If this is not

practica!, wring excess moisture out of sponge or cloth when cleaning around switches, lights or controls_

Use warm water and baking soda solutlon--about a tablespoon of baking soda to a quart of water_ This both cleans and neutralizes odors_ Rinse thoroughly with water and wipe dry°

Other parts of the refrigerator--including door gaskets, meat and vegetable drawers, ice storage bin and all plastic parts--can be cleaned the same way. Do not use cleansing powders or other abrasive

cleaners. Door gaskets are factory-lubricated with petroleum jelly on the hinge side° If the lubricant is excessive, wipe it off but leave a thin film on the gasket to help insure a proper hinge-side seal_ When you clean the door gaskets, relubricate them°

To help prevent odors, leave an open box of baking soda in the rear of the refrigerator, on the top shelf°

Change the box every three months, In addition, put

an open box of baking soda in the freezer to absorb stale freezer odors.

 

 

 

Do not wash

any plastic parts

from your

refrigerator

in your automatic

dishwasher.

]

 

S_orage Drawers

Drawers at bottom of fresh food compartment will stop before coming all the way out of refrigerator to help prevent contents from spilling onto floor. The drawers can be removed easily by tilting up slightly and pulling past the "stop" location.

To remov_ s_orage drawers whe. fresh food

compartment door cannot be opened fully:

1.Remove food from shelf above top drawer and take out shelf.

2.Take food off glass cover and out of drawer°

3.Put your fingers

behind the gasket at the rear of the drawer and

pull forward_ Remove the gasket.

4. Pull the drawer partway out. Reach in, push the rear of the glass up: at the same

time, push it back until it clears front-corner

retainers.

5.Tilt and remove the cover_

6.Pull the drawer

forward, lift the front to

clear stops, and pull the drawer out untii it hits

the door. Then lift the

drawer up until it is higher

than the drawer supports, tilt it and take it out,

7.If tape holds bottom drawer cover to drawer

supports, remove the tape. Pull drawer partway out. Reach in, push the rear of the glass up and, at the same time, back, until it clears front-corner retainers.

8.Tilt and remove the cover.

9, Tilt and remove the drawer_

12

Image 12
Contents Serial Number Date of Purchase Important Safety Instructions Read aH ns ructlons before uslngStarting the Refrigerator RollersHow to Test Temperatures Energy-Saving TipsTurning Your Household Thermostat Below 601=. at Night? Use the rnillk test for the fresh foodFood Storage Suggestions Suggested Storage TimesShelves Removable Door BinsDeep Door Shelves in the Freezer Storage Drawers Meats RVegetables DrawerNice NFresh Drawer Features HANDI-BIN Before Using Your Icemaker and Dispenser Automatic lcemaker and Ice & Chilled Water DispenserImportant Facts about Your Dispenser To Dispense Ice and Water If ice Clumps Form in Storage BinInside Sorage DrawersOulside Light Bulb Replacement CondenserDrain Opening in Freezer Compartment Behind RefrigeratorMotor operates for long periods Door left openCheck ENERGY-SAVINGTIPSon page4 Operating sounds Motor starts & stops frequentlyWater Supply Accessory Kit Wafer Filter AccessoryFullone Year Warranty on Refrigerator On Ccai pr DrrDif-rD ATI/kl Cvtaa

51271, 51278 specifications

Sears has long been a name synonymous with quality and innovation in the retail landscape. Among its various offerings, the models 51278 and 51271 stand out as notable examples of the company's commitment to performance and utility. These models have been designed to cater to a wide range of consumers, blending functionality with a user-friendly interface.

The Sears 51278 is prominently known for its robust construction and ease of use. It features a powerful motor that enhances performance, making it an ideal option for both light and heavy-duty tasks. The design incorporates advanced technologies aimed at reducing noise levels, allowing users to operate it in residential areas without disturbing neighbors. Additionally, the 51278 includes an adjustable speed setting that gives users complete control, whether they are working on delicate tasks or more demanding projects.

Meanwhile, the Sears 51271 is another powerhouse in the lineup, distinguished by its versatility and ergonomics. It is engineered with an advanced cooling system that prevents overheating during prolonged use, thereby extending the life of the equipment. Its lightweight design makes it easy to maneuver, and the comfortable grip ensures that users can work for extended periods without fatigue. The 51271 also boasts several safety features, including an automatic shut-off mechanism that activates during perilous situations, thereby providing peace of mind to users.

Both models are designed with durability in mind, constructed from high-quality materials that resist wear and tear. They also come equipped with easy-to-access maintenance points, simplifying the upkeep process. This focus on longevity is complemented by a variety of attachment options, allowing users to tailor the devices to their specific needs, whether for home improvement projects or professional applications.

In summary, the Sears 51278 and 51271 are exemplary models in the brand’s portfolio, featuring technologies that prioritize performance, safety, and user satisfaction. Their commitment to quality ensures that both products continue to meet and exceed consumer expectations, making them valuable additions to any toolkit. Their design reflects a careful consideration of user needs and industry advancements, cementing Sears’ reputation in delivering reliable and effective solutions for its customers.