Roberts Radio RD-28 manual Mains supply, Fuse

Page 14

Mains supply

The RD-28 will operate from a supply of AC 230 volts, 50Hz only.

DO NOT cut off the mains plug from this equipment. If the plug fi tted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved exten- sion lead or adaptor. If in doubt consult your dealer.

If nonetheless the mains plug is cut off, remove the fuse and dispose of the plug immediately to avoid a possible shock hazard by inadvertent connection to the mains supply.

If this product is not supplied with a mains plug, or one has to be fi tted, then follow the instructions given below:

IMPORTANT. DO NOT make any connection to the larger terminal which

is marked with the letter E or by the safety earth symbol or coloured Green or Green-and-yellow.

The wires in the mains lead are coloured in accordance with the following codes :-

The wire coloured BLUE must be connected to the terminal marked N or coloured BLACK.

The wire coloured BROWN must be connected to the terminal marked L or coloured RED.

BLUE - NEUTRAL BROWN - LIVE

Fuse

When replacing the fuse only a 3AASTA approved to BS1362 type should be used and be sure to re-fi t the fuse cover.

IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN.

Replacement fuse holders are available from Roberts Radio Technical

Services at the address shown on the rear of this manual.

13

Image 14
Contents Roberts Contents Controls Top Battery operation Mains operationOperating your radio Selecting a station Secondary services Display modesFinding new stations AutoselectManual tuning Signal strength displayFavourite button Recalling your favourite stationSystem reset Display backlight Headphone socketLine out socket Specifications Circuit FeaturesGeneral Mains supply FuseGuarantee Roberts Radio Technical Services