2)Press and hold the function control button until the status indicator blinks amber.
3)All connected SSVCs will now be in Active mode.
To turn Off Smart Select™ System and connected source equipment (System Off feature, Smart AC™ Power Controller required)
1)On any SSVC, press the function control button until the status indicator light is red.
2)Press and hold the function control button until the status indicator blinks amber, and then turns red.
3)All connected SSVCs will now be in Mute mode.
4)Press and hold the function control button again until the status indicator blinks amber.
5)The status indicator will no longer be illuminated.
6)The SSVCs are now in Standby mode and the AC power to the components connected to the Smart AC™ Power Controller is turned Off according to the settings of the Smart AC™ Controller (see Smart AC™ instruc- tion manual).
To turn On Smart Select™ System and connected source equipment (System On feature Smart AC™ Power Controller required)
1)On any SSVC, press the function control button once. The status indicator will light green.
2)The SSVC is now in Active mode. All other SSVCs will be in Mute mode. AC Power to the components con- nected to the Smart AC™ Power Controller is turned on according to the settings on the Smart AC™ Controller (see Smart AC™ instruction manual).
7.Specifications Audio-
•Power rating / channel:
•126 watts power handling
•14 watts RMS, continuous
•Uses
•Accepts up to 12 AWG wire.
•Attenuation: 12 steps, including “Off” 43dB total attenuation
•2 channel stereo control
•Can be used with any combination of 4 Ohm to 8 Ohm speakers and amplifiers.
•Frequency response: 20Hz - 20kHz, +1 /
DC power-
•Input voltage: +12 VDC
•Power consumption: 80 mA, .96 watts
Mounting-
•Fits into most 20 cubic in. Junction boxes. 1 5/8”W x 2 7/8”H x 2 5/8”D (4.1 x 7.3 x 5.4 cm)
Weight-
•1.1 lbs (.5 kg)
8. Limited Warranty
The Russound Smart Select™ Volume Control is fully guaranteed for Two (2) years from the date of purchase against all defects in materials and workmanship. During this period Russound will replace any defective parts and correct any defect in workmanship without charge for either parts or labor. For this warranty to apply, the unit must be installed and used according to its written instructions. If service is necessary, it must be performed by Russound. The unit must be returned to Russound at the owner’s expense and with prior written permission. Accidental damage and shipping damage are not con- sidered defects under the terms of the warranty. Russound assumes no responsibility for defects resulting from abuse or ser- vicing performed by an agency or person not specifically authorized in writing by Russound. Damage to or destruction of components due to improper use voids the warranty. In these cases the repair will be made at the owner’s expense. To return for repairs, the unit must be shipped to Russound at the owner’s expense, along with a note explaining the nature of the service required. Be sure to pack in a corrugated container with at least 3 inches of resilient material to protect the unit from damage in transit.
5